15
●
Basic Setup
Setup to the SINGLE mode
Perform the following to set up the unit to the SINGLE mode
for the first time.
1 Power OFF
Confirm that the power of the recorder and the exten-
sion units are turned off.
2 SINGLE
Set the MODE switch inside the front lid of the extension
unit to SINGLE.
3 Turn on the power switch of the extension units.
4 Turn on the power switch of the recorder.
→
The recorder will start.
5 HDD SAFETY MODE OFF
"HDD SAFETY MODE" menu will open after completing
the system check. Select OFF on the menu and press
the SET button on the recorder’s front panel.
→
The recorder will restart.
Notes:
• It will take about 3 or 5 minutes to complete the sys-
tem check.
• When the system has been already run, "HDD
SAFETY MODE" menu will not appear. Skip to step
6.
6 HDD DISK MENU will appear when the system check is
completed.
Perform formatting on the menu.
Refer to "
■
Formatting the Hard Disk" of the operating
instructions of the recorder.
■
Setup Procedures
The following pages describe procedures on how to set up or change the disk mode, how to recover data in RAID5, or
how to check the unit number using the HDD SAFETY MODE.
Notes:
• Refer to the operating instructions of the digital disk recorder WJ-HD316A/WJ-HD309A series for setup menu opera-
tions.
• The MODE switches of all units in a system should be set
to the same position, SINGLE or RAID5.
• The HDDs should be installed in the proper positions in the
order as shown in the figure. Do not skip or reverse the
order of the HDD positions. Otherwise, the recorder will not
recognize the extension unit.
• Do not change HDD positions of the extension unit after once the system has been operated. Otherwise, it will be
impossible to read the recorded data.
• The power-on order should be the extension units first and then the recorder. The power-off order should be the
recorder first and then the units.
• At least, three hard disk drives per extension unit are needed to run it in the RAID5 mode.
Digital Disk Recorder
WJ-HD300A
HDD DISK MENU
TOP MENU
FORMAT
MIRROR ON
REMOVE LINK
RESTART
EXIT
MIRROR OFF
Information of recording areas : [SETUP/ESC] OK : [SET]
160GB
160GB
160GB
160GB
*(160GB)
ADD (160GB)
160GB
LOST
MAIN
EXT1
EXT2
EXT3
EXT4
EXT5
EXT6
EXT7
160GB
160GB
160GB
160GB
*(ERROR)
ADD (ERROR)
160GB
-
160GB
160GB
160GB
160GB
160GB
160GB
-
160GB
160GB
160GB
160GB
160GB
160GB
-
-
-
1
2
3
4
SINGLE RAID5
MODE
SET
HDD 2
HDD 1
HDD 4
HDD 3
POWER