11
7.
Place the brackets with the fixed HDDs into the unit and
fix them using the four screws removed in step 3.
• Do not use an electric screwdriver to fix them.
Recommended tightening torque = 0.784 N · m
{8 k
g
f · cm}
8.
Connect the cables.
9.
Attach the metal plate removed in step 2 with the six
screws (marked with
∆
) previously removed.
10.
Connect the detached harness as it was.
11.
Attach the front cover as it was.
11-1 Align the left edges of both the front cover and the
unit, and then push the front cover onto the unit.
11-2 Slide the front cover to the right.
Note:
The front cover may be attached and detached
as necessary in the next step of Setup Procedures.
Be careful not to damage the harness.
12.
Mount the unit referring to Mounting in a Rack.
13.
Connect the unit referring to Connections.
14.
Set up the unit referring to Setup Procedures.
15.
Attach the front cover as it was.
15-1 Align the left edges of both the front cover and the
unit, and then push the front cover onto the unit.
15-2 Slide the front cover to the right.
15-3 Tighten the two screws.
