72
CONTENTS UPLOAD
Contents can be uploaded by means of an FTP (File
Transfer Protocol). The following describes how to upload
contents produced by using a PC.
■
Uploading a File
Upload contents produced by using a PC by the follow-
ing procedures.
q
Click the
[Start]
button, point to
Programs
, and then
click
MS-DOS Prompt
to open the MS-DOS window.
w
Enter an FTP command in the MS-DOS window and
start the FTP. Then enter the IP address of the WJ-
NT104.
C:\CONTENTS>FTP 192.168.0.10
e
In response to the input request for a user account, log
in the user at the administrator level (Level 1).
User (192.168.0.10 : (none)) : admin
r
Enter a password.
Password:
t
After finishing the log-in operation, enter “
bin
” to select
a binary transmission mode.
ftp>
bin
y
Enter a put command to upload the file.
ftp>
put upload.html
u
After finishing the transmission, enter “
quit
” to exit from
the FTP.
ftp>
quit
Notes
To transmit more than one file at a time, enter “prompt”
to release the interactive mode, and follow “mput” of
the input command with a wild card symbol (for exam-
ple, “*”).
ftp>prompt
Interactive mode off
ftp>mput
*
.html
■
Content Storage Memory
• Content files such as HTML that have been uploaded
by means of the FTP are stored in the flash ROM of the
WJ-NT104. Hence, they are protected from erasure
when the power switch is turned off. However, they are
returned to an initial state during version-up operation
or if reset after turning on the Mode Setup Switch “
2
” of
the WJ-NT104. Be sure to back up the files before
attempting to conduct such operations.
• No directories can be prepared in the content memory
interior.
• Reading of the contents file name is case-sensitive.
Storing capacity:
Approx. 1.5 Mbytes in total
Number. of storable files : Max. 650
* The above figures are subject to change, depend-
ing on file sizes and memory usage.
