FAQs | Maintenance
85
Problem
Causes / Actions
Other
The TV does not switch on
●
Check the mains lead is plugged into the TV and the socket outlet.
The TV goes into Standby
mode
●
Auto power standby function is activated.
(p. 10)
●
The TV enters Standby mode about 30 minutes after analogue broadcasting ends.
The remote control does
not work or is intermittent
●
Are the batteries installed correctly?
(p. 7)
●
Has the TV been switched on?
●
The batteries may be running low. Replace them.
●
Point the remote control directly at the TV’s remote control signal receiver (within about
7 m and a 30 degree angle of the signal receiver).
●
Situate the TV away from sunshine or other sources of bright light not to shine on the
TV’s remote control signal receiver.
Parts of the TV become
hot
●
Even when the temperature of parts of the front, top and rear panels has risen, these
temperature rises do not cause any problems in terms of performance or quality.
The LCD panel moves
slightly when it is pushed
with a finger
Clattered sound might be
heard
●
There is some flexibility around the panel to prevent damage to the panel.
●
The panel might move slightly when it is pushed with a finger, and clattered sound might
be heard. This is not a malfunction.
Overcurrent error
message appears
●
The connected USB device might cause this error. Remove the device and try
unplugging the mains plug for a few minutes and connecting it again.
●
Check foreign objects are not inside the USB port.
An error message appears
●
Follow the message’s instructions.
●
If the problem persists, contact your local Panasonic dealer or the authorised service
centre.
Maintenance
First, remove the mains plug from the socket outlet.
Display panel, Cabinet, Pedestal
Regular care:
Gently wipe the surface of the display panel, cabinet,
or pedestal by using a soft cloth to clean the dirt or
fingerprints.
For stubborn dirt:
First clean the dust on the surface. Dampen a soft cloth with clean
water or diluted neutral detergent (1 part detergent to 100 parts
water). Wring the cloth and wipe the surface. Finally, wipe away all
the moisture.
Caution
●
Do not use a hard cloth or rub the surface too hard, otherwise this may cause scratches on the surface.
●
Take care not to subject the TV’s surfaces to water or detergent. Liquid inside the TV could lead to product failure.
●
Take care not to subject the surfaces to insect repellent, solvent, thinner or other volatile substances. This may degrade
surface quality or cause peeling of the paint.
●
The surface of the display panel is specially treated and may be easily damaged. Take care not to tap or scratch the surface
with your fingernail or other hard objects.
●
Do not allow the cabinet and pedestal to make contact with a rubber or PVC substance for a long time. This may degrade
surface quality.
Mains plug
Wipe the mains plug with a dry cloth at regular intervals. Moisture and dust may lead to fire or electrical shock.
Содержание Viera TC-L42ET5W
Страница 88: ...Note ...
Страница 89: ...Note ...
Страница 178: ...Nota ...
Страница 179: ...Nota ...