Se
tup
Inserting/removing an SD card
34
LSQT1025
Inserting/removing an SD card
Before inserting/removing an SD card, be sure to set the OFF/ON switch to OFF.
1 Set the OFF/ON switch to OFF to turn off the power.
≥
Check that the status indicator has gone off.
2 Open the card slot cover.
3 Insert/remove the SD card into/from the card slot.
≥
When inserting an SD card, face the label side
A
upwards and press
it straight in with one stroke as far as it goes.
≥
When removing the SD card, press the centre of the SD card and
then pull it straight out.
4 Securely close the card slot cover.
∫
Concerning the SD card
≥
Electrical noise, static electricity or failure of this unit or the SD card may damage or erase the
data stored on the SD card. We recommend saving important data on a computer.
∫
Card access lamp
≥
When this unit accesses the SD card (reading, recording, playback,
erasing, etc.), the access lamp lights up.
≥
If the following operations are performed when the access lamp is lit,
then the SD card or the recorded data may be damaged or this unit
may malfunction.
– Removing the SD card
– Operating the OFF/ON switch or the mode dial
– Removing the battery or disconnecting the AC adaptor
If the SD card is inserted or removed while the OFF/ON switch is set to ON, this unit may
malfunction or the data recorded on the SD card may be lost.
A
LSQT1025(ENG).book 34 ページ 2006年2月4日 土曜日 午後6時10分