Safety Precautions
Please follow these general guidelines before servicing the models mentioned in this
technical guide.
1. While servicing, please observe the
original lead dress
. If a
short circuit
is
found,
replace all the parts
that have been
overheated
or
damaged
by the
short circuit.
2. After servicing, please make sure that all the protective devices such as
insulation barriers, and insulation paper shields are properly installed.
3. Some semiconductor (solid state) devices can be easily damaged by
static
electricity
. Such components are commonly called Electrostatically Sensitive
(ES) devices. Examples of typical ES devices are
integrated circuits,
some
field-effect transistors
(FET)
and semiconductor
"chip"
components. The
following techniques should be used to help reduce the incidence of component
damage caused by Electro Static Discharge (ESD).
4.
Drain off any Electro Static Discharge
on your body by touching a known earth
ground, immediately before handling any semiconductor component or
semiconductor-equipped assembly.
Alternatively, obtain and
wear a
commercially available discharging ESD wrist strap
, which should be
removed prior to applying power to the unit as it may cause an electric shock.
5. After removing an electrical assembly equipped with ES devices,
place the
assembly on a conductive surface such as an aluminum foil,
to prevent
electrostatic charge buildup or exposure on the assembly.
6. Use a
grounded-tip soldering iron
to solder or unsolder ES devices.
7. Use an
anti-static solder removal device
. Some solder removal devices not
classified as "anti-static (ESD protected)" can generate electrical charge
sufficient enough to damage an ES device.
8. Do not use freon-propelled chemicals. These can generate electrical charge
sufficient enough to damage an ES device.
9. Do not remove a replacement ES device from its protective package until you are
just ready to install it. (Most replacement ES devices are packaged with leads
electrically shorted together by conductive foam, aluminum foil or comparable
conductive material).
10. Immediately before removing the protective material from the leads of a
replacement ES device, touch the protective material to the chassis or the circuit
assembly into which the device will be installed.
Caution:
Please make sure that no power is applied to the chassis or circuit
assembly, and observe all other safety precautions.
11. Minimize bodily motions when handling unpackaged replacement ES devices.
(Harmless motions such as the brushing together of your clothes fabric or the
lifting of your foot from a carpeted floor can generate static electricity sufficient
enough to damage an ES device).
3
Содержание TH37PX50U - 37" HD PLASMA TV
