English
58
Onscreen display
Set to display / hide the following Onscreen display.
●
Power on display
●
Input signal switch display
●
No signal display
●
MUTE display after displaying the menu screen
●
MUTE and off timer remaining time display after
<RECALL> is pressed
●
Off timer remaining time display when 3 minutes
remaining
[On]:
Displays the Onscreen display.
[Off]:
Hides the Onscreen display.
Initial input
Adjusts the input signal when the unit is turned on.
[Off] / [HDMI1] / [HDMI2] / [HDMI3] / [HDMI4] /
[DisplayPort] / [DIGITAL LINK] / [DVI-D] / [PC] /
[SDI1]
*
*
: When a Terminal Board is installed to the SLOT, its
Terminal name will be displayed.
Note
●
This menu is available only when [Input lock] is [Off].
(see page 58)
Initial VOL level
Adjusts the sound volume level when the unit is turned
on.
[Off]:
It will be the sound volume level which had
been set before the power of the unit was
turned off.
[On]:
Sets your preferred volume.
●
You can hear the changed volume regardless of your
volume setting before opening the [Options] menu if
you adjust the volume when [Initial VOL level] is [On]
and cursor is on the menu.
■
To adjust sound volume level
Press <VOL +> <VOL ->.
Note
●
When [Maximum VOL level] is [On], the volume
can only be adjusted between 0 and your maximum
range. (see page 58)
Maximum VOL level
Adjusts the maximum volume.
[Off]:
The sound volume level can be set up to 63
(maximum).
[On]:
The sound volume level will not exceed the
set point.
■
To adjust sound volume level
Press <VOL +> <VOL ->.
Note
●
When the [Maximum VOL level] is set lower than the
[Initial VOL level], the [Initial VOL level] automatically
becomes the same as the [Maximum VOL level].
The volume display can go up to 63 regardless of the
settings.
●
You can hear the changed volume regardless of your
volume setting before opening the [Options] menu if
you adjust the volume when [Maximum VOL level] is
[On] and cursor is on the menu.
Input lock
Locks the input switch operation.
[Off] / [HDMI1] / [HDMI2] / [HDMI3] / [HDMI4] /
[DisplayPort] / [DIGITAL LINK] / [DVI-D] / [PC] /
[SDI1]
*
*
: When a Terminal Board is installed to the SLOT, its
Terminal name will be displayed.
Note
●
Input switch can be used when this is set to [Off].
