English
18
Pin assignments and signal names for DVI-D
Input Connector
Pin No.
Signal Name
T.M.D.S. data 2-
T.M.D.S. data 2+
T.M.D.S. data 2 shield
DDC clock
DDC data
T.M.D.S. data 1-
T.M.D.S. data 1+
T.M.D.S. data 1 shield
+5 V DC
GND (Ground)
Hot plug detect
T.M.D.S. data 0-
T.M.D.S. data 0+
T.M.D.S. data 0 shield
T.M.D.S. clock shield
T.M.D.S. clock+
T.M.D.S. clock-
PC IN terminal connection
Connect a cable
which matches
the audio output
terminal on the
computer.
(not supplied)
(Male)
(Female)
Shared with DVI-D IN.
Mini D-sub 15p (not supplied)
Conversion adapter (if necessary) (not supplied)
Stereo mini plug (M3)
COMPUTER
The type of computer signal that can be connected
●
With regard to the typical PC input signals that
are described in “Preset Signals” (see page 77),
adjustment values such as for the standard picture
positions and sizes have already been stored in this
unit. You can add up to eight PC input signal types
that are not included in the list.
●
Computer signals which can be input are those with
a horizontal scanning frequency of 15 to 110 kHz and
vertical scanning frequency of 48 to 120 Hz.
●
The display resolution is a maximum of 1 440 × 1 080
dots when the aspect mode is set to [4:3], and 1 920
× 1 080 dots when the aspect mode is set to [16:9].
If the display resolution exceeds these maximums, it
may not be possible to show fine detail with sufficient
clarity.
●
In [ENGLISH(US)] OSD language, [16:9] is displayed
as [FULL].
Note
●
The PC IN terminal is DDC2B-compatible. If the
computer being connected is not DDC2B-compatible,
you will need to make setting changes to the
computer at the time of connection.
●
Some PC models cannot be connected to the set.
●
There is no need to use an adapter for computers
with DOS/V compatible Mini D-sub 15P terminal.
