38
Adjusting POSITION
1
Press to display the Position menu.
Position
Default
Default
Auto setup
H-position
0
H-size
0
V-position
0
V-size
0
1:1 pixel mode
Off
2
Select to adjust each item.
Press to select the menu to adjust.
Press to adjust the menu.
Note:
•
Unadjustable items are grayed out. Adjustable
items differ depending on the input signal and the
display mode.
3
Press to exit from adjust mode.
Note
:
• If a “Cue” or “Rew” signal from a VCR or DVD player is received, the picture position will shift up or down. This
picture position movement cannot be controlled by the Position function.
Auto Setup
H-position/V-position, H-Size/V-Size, Dot Clock and Clock Phase are automatically adjusted.
When "Multi-screen setting" is "ON", this does not operate.
This setting only operates when a PC signal is input, and the aspect is “16:9”.
Using Remote Control
When
on the remote control is pressed, “Auto Setup” will be
executed.
When Auto Setup does not work, “Invalid” is displayed.
Notes:
•
Auto Setup may not work when a cropped or dark image is input. In such case, switch to a bright
image with borders and other objects are clearly shown, and then try auto setup again.
• Depending on the signal, out of alignment may occur after Auto Setup. Carry out fine tuning for the
position/size as required.
• If Auto Setup cannot set properly for vertical frequency 60Hz XGA signal (1024×768@60Hz,
1280×768@60Hz and 1366×768@60Hz), pre-selecting the individual signal in “XGA Mode” (see page
43) may results in correct Auto Setup.
•
Auto Setup does not work well when a signal such as additional information is superimposed out of
valid image period or intervals between synchronizing and image signals are short.
• If Auto Setup cannot adjust correctly, select “Default” once and press ENTER then adjust Position
manually.
•
If the picture goes off screen in the horizontal direction as a result of performing Auto Setup, perform
Dot Clock adjustment.