30
Picture Adjustments
Item
Effect Adjustments
Notes:
+ You can change the level of each
function (Backlight, Contrast,
Brightness, Colour, Tint, Sharpness)
for each Picture Mode.
+ The setting details for Normal,
Dynamic and Cinema respectively
are memorized separately for each
input terminal.
+ The “Tint” setting can be adjusted for
NTSC signal only during Video input
signal.
+ “Backlight” can be adjusted when
“ECO Mode” is set to “Custom” and
“Power save” to “Off”. (see page
37)
Backlight
Darker
Brighter
Adjusts luminance of the back light.
Contrast
Less
More
Adjusts the proper picture contrast.
Brightness
Darker
Brighter
Adjusts for easier viewing of dark
pictures such as night scenes and black
hair.
Colour
Less
More
Adjusts colour saturation.
Tint
Reddish
Greenish
`> x K
Sharpness
Less
More
Adjusts picture sharpness.
Advanced settings
Item
Effect Details
Input level
Less
More
` >&Z K
Gamma
Down
Up
S CURVE
2.0
2.2
2.6
AGC
Off
On
Increases the brightness of dark signal automatically.
W/B High R
Less
More
Adjusts the white balance for light red areas.
W/B High G
Less
More
Adjusts the white balance for light green areas.
W/B High B
Less
More
Adjusts the white balance for light blue areas.
W/B Low R
Less
More
Adjusts the white balance for dark red areas.
W/B Low G
Less
More
Adjusts the white balance for dark green areas.
W/B Low B
Less
More
Adjusts the white balance for dark blue areas.
Notes:
+ Carry out “W/B” adjustment as follows.
1. Adjust the white balance of the bright sections using the “W/B High R”, “W/B High G” and “W/B High B” settings.
2. Adjust the white balance of the dark sections using the “W/B Low R”, “W/B Low G” and “W/B Low B” settings.
3. Repeat steps
1
and
2
to adjust.
Steps
1
and
2
affect each other’s settings, so repeat each step in turn to make the adjustment.
+ The adjustment values are memorized separately for each input terminal.
+ The adjustment range values should be used as an adjustment reference.
Helpful Hint: (
/
Normalise
Normalisation)
On the remote control unit, while the “Advanced settings” menu is displayed, if either the N button is pressed at any time
or the ACTION ( ) button is pressed during “Normalise”, then all adjustment values are returned to the factory settings.