2-19
8
Referring to Fig. 4-5-3, reconnect the following connec-
tors by using the Extension Cable Ass'y (Refer to Fig.1-4,
1-5) for Adjustment.
1. Connect the Extension Cable
A
(Refer to Fig.1-4)
between CN201 on the Main Board and the Lens
Ass'y.
2. Connect the Extension Cable
B
(Refer to Fig.1-5)
between CN300 on the Main Board and CN500 on the
Sensor Board.
8
Reconnect the Flexible Flat Cable of the Tilt Board
(CN400) to CN204 on the Main Board.
8
Reconnect the Flexible Flat Cable of the Servo Board
(CN1) to CN4 on the Main Board.
8
Supply the Power to the WV-CW970/WV-CW974, and
the Camera Head starts panning.
8
After the Camera Head stops panning, mount the
Camera Head on the CCD Mounting Adjustment Jig as
shown in Fig. 4-5-4.
Note:
Align the small projection of the Camera Head and
the black line on the Upper Plate.
8
Adjust the Lens for the fully wide angle position using the
Remote Controller.
8
Loosen two screws that secure the Sensor Board as
shown in Fig. 4-5-5.
8
Observing the Monitor Screen, adjust the position of the
Sensor Board so that the hole on the Bottom Plate comes
to the center of the Monitor Screen as shown in Fig. 4-5-
6.
8
Adjust the position of the Sensor Board so that the hori-
zontal black line on the Bottom Plate aligns to the hori-
zontal line on the Monitor Screen as shown in Fig. 4-5-6.
8
Repeat above adjustment until the hole position remains
at the center of the Monitor Screen while zooming in/out
of the Lens.
8
Fasten two screws on the Sensor Board.
Cross-line
Black Line
on the Bottom Plate
Hole on the Bottom Plate
Fig. 4-5-6
Fig. 4-5-3
Fig. 4-5-4
Camera Head
CCD Mounting
Adjustment Jig
Fig. 4-5-5
Loosen two screws.
Sensor
Board
Camera
Head
Flexible
Flat Cable
of the
Servo
Board
CN204
CN4
Flexible
Flat Cable
of the
Tilt Board
Camera Head
Flexible
Flat Cable
of the
Lens Ass'y
Extension Cable
A
Extension
Cable
B
CN500
Sensor
Board
CN300
CN201
Main Board
