2-16
y
After confirming that there is no other object between the
Camera and the Radiation Chart, press the
ENTER
key.
u
Wait about 40 seconds until finishing the Back Focus
adjustment.
i
Confirm that the picture is clearly visidle during zooming
wide.
o
If the picture is not clearly viside, press
ESC
key, and
select the item
"1.2. BACK FOCUS ADJ"
with the
ARROW
key, and press the
ENTER
key.
!0
Repeat above adjustment steps
y
to
o
until the picture
becomes fine.
!1
After completing of the adjustment, press the
QUIT (F3)
key.
!2
If you want to save, press the
Y
key, and then press the
ENTER
key, Type
xxxxxxxx.EV2 B40 19FF
. Give an
appropriate file name for
xxxxxxxx
within 8 letters, but
do not use
CW97C
. Then press the
ENTER
key to finish
this adjustment procedure.
!3
If you don't want to save, press the
N
key, and then press
the
ENTER
key to finish this adjustment procedure.
4.3 Tilt Adjustment
Note:
This Tilt Adjustment is required in the following cases;
1. Replacing the CCD Image Sensor.
2. Replacing the Sensor Board.
3. Replacing the Tilt Board.
4.3.1. Starting E.V.R. Adjustment Program
8
Insert new floppy disk containing DOS Operating System
and the E.V.R. Adjustment Program into the computer
(IBM PC/AT) and turn on the Power Switch of the com-
puter.
8
When starting an adjustment, at the prompt, type
RADJ2 CW97TLT
and press the
ENTER
key, an initial
menu page as shown in Fig. 4-3-1 will be displayed.
4.3.2. Saving the Adjustment Data
This saving procedure is recommended to keep the current
adjustment status of the camera.
8
Press the
SAVE (F5)
key of the computer, and the com-
puter will ask you for the file name.
8
Type
xxxxxxxx.EV2 B40 19FF
. Give an appropriate file
name for
xxxxxxxx
within 8 letters, but do not use
CW97C
.
8
Press the
ENTER
key.
4.3.3. Loading the Adjustment Data
This loading procedure is recommended to return the adjust-
ment status of the camera to the factory default setting or
the setting you saved before.
8
Press the
LOAD (F1)
key of the computer, and the com-
puter will ask you for the file name.
8
Type
CW97C.EV2
or
xxxxxxxx.EV2
(
xxxxxxxx
means a
file name you named before.) and press the
ENTER
key.
Fig. 4-3-1
PANASONIC REMOTE EVR ADJUSTMENT SYSTEM CCTV PRODUCT: CW970 EEPROM:0
MENU
Page (1/1)
NTSC
1. PAN/TILT POSITION-1
2. PAN/TILT POSITION-2
3. TILT RE-ADJ
4. PAN/TILT POSITION-1
5. PAN/TILT POSITION-2
<CONTENTS> PAN/TILT
<INSTRUCTION> PLEASE CHOOSE MENU DATA BY ARROW-KEY
LOAD (F1) QUIT (F3) SAVE (F5)
