![background image](http://html.mh-extra.com/html/panasonic/super-dynamic-iii-wv-cw384/super-dynamic-iii-wv-cw384_operating-instructions-manual_277664027.webp)
27
• Select a proper "FINE" phase so that the two video signals on the oscilloscope come as close as possible.
Notes:
• Moving the "I" cursor across the +/- end will shift the "FINE" range.
• Press the [LEFT] and [RIGHT] buttons simultaneously to reset the "V PHASE" to the default (0 degree).
• Keep pressing the [LEFT] and [RIGHT] buttons for a second to move the "I" cursor faster if necessary.
• Spike noise if contained in the AC mains may disturb synchronization of LL.
7. White Balance Setting (WHITE BAL)
Select a mode for "WHITE BAL" on the "CAMERA SETUP" menu. The default setting is "ATW1".
ATW1:
Is automatically adaptable to the color temperatures of 2 700 K - 6 000 K.
ATW2:
Is automatically adaptable to the use of sodium lamps (2 000 K - 6 000 K).
AWC:
Is automatically adaptable to the color temperatures of 2 000 K - 10 000 K.
Notes:
• When "ATW1" or "ATW2" is selected, no further operation is required.
• "ATW1" and "ATW2" do not appear on the setup menu of the system controller.
• Select "AWC" in the following cases: the color temperature is out of the 2 000 K - 6 000 K range, the scene contains mostly
high color temperatures such as blue sky or sunset, or the scene is dim.
• When "AWC" is selected, the "AWC" setting is required.
AWC Setting
1. Select "AWC" and press the [LEFT] button.
→
"AWC" will change to "AWC
→
PUSH SW".
2. Press the [SET] button.
→
"PUSH SW" will be highlighted while the "AWC" setting is
performed.
Note:
• If the white balance is not set, "PUSH SW" is being highlighted.
3. Press the [RIGHT] button.
Manual Fine Adjustment
Perform fine adjustment as necessary.
1. Select "WHITE BAL" and press the [SET] button.
→
Fine adjustment menu of ATW or AWC will open.
2. Adjust finely "R" (Red) and "B" (Blue) gain by moving the "I" cursor.
8. Motion Detection Setting (MOTION DET)
When a series of changes in pictures is detected, the camera outputs an alarm to the external device such as a disk recorder.
The recorder will start recording the pictures.
1. Select a mode for "MOTION DET" on the "CAMERA SETUP" menu.
The default setting is "OFF".
OFF:
Disables the alarm output.
MODE1:
Outputs alarm when a series of motions is detected.
MODE2:
Outputs alarm when a series of scene changes is
detected.
→
The "MODE1" menu opens when you select "MODE1" and
press the [SET] button.
2. Adjust for "LEVEL" to optimize the sensitivity of detection.
**ATW1**
R ...I...128
- +
B ...I...128
- +
RET TOP END
** MODE1 **
LEVEL ...I...128
- +
DWELL TIME 2S
DISPLAY MODE
ALARM OFF
MASK SET
RET TOP END
Содержание Super Dynamic III WV-CW384
Страница 73: ...73 ...