![background image](http://html.mh-extra.com/html/panasonic/super-dynamic-iii-wv-cw384/super-dynamic-iii-wv-cw384_operating-instructions-manual_277664031.webp)
31
14. Auto Image Stabilizer (STABILIZER)
This function electronically compensates for an unstable camera image due to movement of a mounting pole or bracket. The
default setting is "OFF".
ON:
Automatically compensates for an unstable image.
OFF:
Image stabilizer will not operate.
Important:
• When set to "ON", some effective pixels on the edge of the CCD are used by the stabilization function. This may result in a
small reduction in resolution and a narrower angle of view. After activating the image stabilizer function, check that the field
of view is correct.
• Image stabilization may not function where there is excessive camera movement or when the scene is low light or low con-
trast objects.
15. LED Setting (LED)
"ON" or "OFF" is selected to decide whether or not to use the LED located on the side of this unit. The default setting is "ON".
ON:
Blinks the LED when the motion detector function (
☞
page 27) detects a change in an image. Lights in the cases other
than the above.
OFF:
Keeps the LED unlit.
16. Back-focus Setting (BACK-FOCUS SETUP)
Perform adjustment of the back-focus (flange-back: the gap between the lens and focal plane) remotely on this menu using a
system controller. After installation, you can perform this adjustment when defocus arises that may be caused by long-term
use, environmental changes, etc.
Important:
• Do not use the ABF function for continuous or repetitive pur-
poses (ex. autofocus etc.). This function is to be used to cor-
rect defocus caused by switching between color and black -
and - white when/after installing the camera.
1. Select "BACK-FOCUS" on the top menu and press the [SET]
button.
→
The "BACK-FOCUS SETUP" menu opens.
2. Select "ABF" and press the [SET] button.
→
Adjustment is automatically performed.
Notes:
• Performing ABF will function to obtain the best focus around the center areas in a scene.
• Performing ABF is available only when "OFF", "X2 AUTO", or "X2 FIX" is selected for "SENS UP".
• Using the ABF function under low light conditions may cause noise.
3. Select "MANUAL-ADJ" and press the [SET] button if manual adjustment is required.
The manual back-focus adjustment screen will open.
• Use the [LEFT] or [RIGHT] buttons to move the "I" cursor and obtain a proper focus.
→
Refer to the 4-digit number on the second bottom line. The larger the number is, the better the focus will be.
• Select "RET" and press the [SET] button to go back to the menu setup.
4. Select a mode for "C/L
←→
B/W". The default setting is "AUTO".
AUTO:
Adjusts the back-focus automatically every time the camera switches the mode between color and black-and-
white. "AUTO" is usable only when "OFF", "X2 AUTO", or "X2 FIX" is selected for "SENS UP".
PRESET:
Adjusts the back-focus to the positions for color mode and black-and-white mode that are preset by performing
step 2 (automatic) or step 3 (manual) under the respective light conditions.
**BACK-FOCUS SETUP**
ABF
→
PUSH SW
MANUAL-ADJ
C/L
←→
B/W AUTO
SETUP-SW LOCK OFF
NEAR FAR
.........I.........
INDICATOR XXXX
RET TOP END
Содержание Super Dynamic III WV-CW384
Страница 73: ...73 ...