Panasonic SD XC WV-SFN480, Руководство по эксплуатации

Страница: 149 / 232

•
When “Quad PTZ” is selected for “Image capture mode”, 1 area can be configured for each image.
2.
Adjust “Detection area” and “Detection sensitivity” using the slider.
Refer to page 144 for further information about the “Detection sensitivity” and “Detection area”.
The currently displayed area and its detection sensitivity will be displayed in the “Detection area” section.
Change areas and the settings of “Detection area” and “Detection sensitivity” as necessary.
3.
Click the [Set] button after completing the settings.
IMPORTANT
•
The setting will not be applied unless the [Set] button is clicked.
4.
To invalidate the VMD area, click the [Set] button after selecting “Off” for “Status” of the VMD area to be
invalidated.
→
The outline of the invalidated VMD area will turn to a dotted line. When the VMD area is invalidated,
no alarm will occur even when a motion can be recognized in the area.
5.
To delete the VMD area, click the [Delete] button corresponding to the area to be deleted.
→
The outline of the respective VMD area will disappear.
6.
Click the [Set] button.
→
The edited settings will be applied.
13.6 Configuration of the settings relating to alarm
notification [Notification]
Click the [Notification] tab on the “Alarm” page. (
®
page 56, page 58)
The settings relating to Panasonic alarm protocol and HTTP alarm notification can be configured in this section.
Operating Instructions 149
13 Configure the alarm settings [Alarm]