Panasonic SD XC WV-SFN480, Руководство по эксплуатации

Страница: 72 / 232

IMPORTANT
•
If an SD memory card with an SD Speed Class other than 10 is used,
2992x2992/2816x2816/2048x2048/2560x1920/2560x1440 cannot be selected for the image capture
size of JPEG images. When recording with H.264, set the maximum bit rate to 6144 kbps.
•
If an SD memory card with an SD Speed Class 10 is used and H.264 is used for recording, set the
maximum bit rate to 16384 kbps.
•
For SD memory cards with an SD Speed Class 10, use a card that supports UHS-I (Ultra High
Speed-I).
•
JPEG cannot be recorded when “Quad stream” is selected for “Image capture mode”.
•
JPEG cannot be recorded when “On(NTSC)” or “On(PAL)” is selected for “Monitor out”.
Note
•
When “H.264(1)” is selected, the settings for “H.264(1)” on the [JPEG/H.264] tab of the “Image/
Audio” page will be changed to the settings for “H.264(1) & recording”.
When “H.264(2)” is selected, the settings for “H.264(2)” on the [JPEG/H.264] tab of the “Image/
Audio” page will be changed to the settings for “H.264(2) & recording”.
•
When using the SD memory recording function of a Panasonic network disk recorder, select
“JPEG(1)” for “Recording format” of “Recording stream”.
•
When “H.264(1)” or “H.264(2)” is selected for “Recording format”, the settings of the following functions
may be corrected.
–
When “VBR” or “Best effort” is selected for “Transmission priority”, “Frame rate” is set.
–
When “High” or “Middle” is selected for “Burst tolerance level”, “Low” is set.
–
When “2s”, “3s”, “4s” or “5s” is selected for “Refresh interval”, “1s” is set.
•
When “H.264(1)” or “H.264(2)” is selected for “Recording format”, the name of the saved file will be
given automatically.
•
When “H.264(1)” or “H.264(2)” is selected for “Recording format”, the number of users that can access
the camera may be reduced.
•
When “On” is selected for “Audio recording”, the maximum value of the available bit rate for H.264 will
be limited.
[Save trigger]
Select a trigger to save images on the SD memory card from the following.
•
FTP error: Saves images when images have failed to transmit to the FTP server by the FTP periodic image
transmission function. Available only for the “JPEG(1)” or “JPEG(2)” images.
•
Alarm input: Saves images at an alarm occurrence.
•
Manual: Saves images manually.
•
Schedule: Saves images in accordance with the settings for “Schedule” (
®
page 197). Available only for
the “H.264(1)” or “H.264(2)” images.
•
Default: FTP error
JPEG recording(Manual)
This setting is only available when “JPEG(1)” or “JPEG(2)” is selected for “Recording format”, and “Manual” is
selected for “Save trigger”.
[File name]
Enter the file name used for the image to be saved on the SD memory card. The file name will be as follows.
72 Operating Instructions
10 Configure the basic settings of the camera [Basic]