RQTX0165
35
Error messages
Display
Check point/Cause/Countermeasure
Pages
Set the same remote control code for this system and remote control.
If
“REMOTE 2”
is displayed, set remote control code to
“2”
.
If
“REMOTE 1”
is displayed, set remote control code to
“1”
.
•
34
The equipment connected by the HDMI cable is not compatible with this
system’s copyright protection technology.
•
—
The system is receiving video signals that are incompatible with it through
HDMI connection. Check the settings of the connected equipment.
•
—
A problem has occurred with the HDMI connection. Try the following to correct
the problem. Consult your dealer if the error code remains on the display.
―
Turn the connected equipment off and on again.
―
Disconnect the HDMI cable then reconnect it.
―
Do not connect more than 2 equipment in series to the output of this system.
•
—
—
—
(Scrolling)
You cannot use Dolby Virtual Speaker, Dolby Pro Logic and SFC for dual
sounds.
•
32
(Scrolling)
You cannot use Dolby Virtual Speaker, Dolby Pro Logic and SFC effect with
PCM signals with sampling frequency over 48 kHz.
SFC is not available for multi-channel LPCM signal.
•
•
26
26
AMPLIFIER SECTION
RMS Output Power of each channel driven
10 % total harmonic distortion
1 kHz Front CH
70 W per channel (4
Ω)
1 kHz Center CH
70 W per channel (4
Ω)
100 Hz Subwoofer CH
90 W per channel (3
Ω)
Total RMS Output Power
300 W
Rated minimum sine wave RMS power output
1 % total harmonic distortion (Dolby Digital Mode)
120 Hz - 20 kHz Front CH
45 W per channel (4
Ω)
120 Hz - 20 kHz Center CH
43 W per channel (4
Ω)
45 Hz - 120 Hz Subwoofer CH
57 W per channel (3
Ω)
Total FTC Output Power
190 W
Rated minimum sine wave RMS power output
1 % total harmonic distortion (Stereo mode)
120 Hz - 20 kHz Front CH
47 W per channel (4
Ω)
45 Hz - 120 Hz Subwoofer CH
57 W per channel (3
Ω)
Total FTC Output Power
151 W
Total harmonic distortion
half power at 1 kHz (Front CH)
0.5 % (4
Ω)
Input sensitivity
TV, AUX 3
450 mV, IHF’66
S/N at rated power
BD/DVD, TV, AUX 1, AUX 2
80 dB
Input impedance
TV, AUX 3
47 k
Ω
Tone controls
BASS
50 Hz, +6 dB to -6 dB
TREBLE
20 kHz, +6 dB to -6 dB
Digital input/output
HDMI Input
1
HDMI Output
1
Optical digital input
2
Coaxial digital input
1
This system supports “HDAVI Control 3” function.
Analog input/output
Analog audio input
2
OPERATING CONDITIONS:
Operating temperature range:
0°C to +40°C
(
+32°F to +104°F
)
Operating humidity range:
20% to 80% RH (no condensation)
Specifications
GENERAL
Power supply
AC 120 V, 60 Hz
Power consumption
Main set
68 W
Standby (HDMI ON)
0.7 W
Standby (HDMI OFF)
0.3 W
SPEAKER SYSTEM
FRONT (L/R)
1-Way 1 Speaker System (Bass Reflect)
6.5 cm (2
1
/
2
”
) Cone Type Full Range x1
Input power (IEC)
70 W (Max/4
Ω
)
Output sound pressure level
79 dB/W (1.0 m)
Frequency range
80 Hz - 25 kHz (-16 dB)
95 Hz - 22 kHz (-10 dB)
CENTER
1-Way 1 Speaker System (Bass Reflect)
6.5 cm (2
1
/
2
”
) Cone Type Full Range x1
Input power (IEC)
70 W (Max/4
Ω
)
Output sound pressure level
79 dB/W (1.0 m)
Frequency range
80 Hz - 25 kHz (-16 dB)
95 Hz - 22 kHz (-10 dB)
SUBWOOFER
1-Way 2 Speaker System (Bass Reflect)
13 cm (5
1
/
8
”
) Cone Type Woofer x2
Input power (IEC)
90 W (Max/3
Ω
)
Output sound pressure level
82 dB/W (1.0 m)
Frequency range
35 Hz - 600 Hz (-16 dB)
42 Hz - 500 Hz (-10 dB)
RACK SYSTEM
(INCLUDING SPEAKER)
Dimensions (W x H x D)
1300 mm x 444 mm x 458 mm
(51
1
/
8
” x 17
15
/
32
” x 18
1
/
32
”)
Mass
approx. 50k
g
(110.2 Ibs)
Mass is a Completed (AMP, Speaker Unit inc)
Maximum Loading Weight
80 k
g
(176.4 Ibs)
Rating with low-cut filter equipped amplifier
Note
1. Specifications are subject to change without notice.
2. Total harmonic distortion is measured by the digital spectrum
analyser.
Reference
Error messages/Specifications
SC-HTR310 (RQTX0165-P) - 14.07.08.indd 35
7/16/2008 1:52:25 PM