OTHER OPERA
TIONS
ENGLISH
38
RQT8043
RQTX0059
Operating the television
You can use the remote control to operate a
Panasonic television.
Aim the remote control at the television.
To switch the television on or off
To switch the television’s video input mode
Adjust the volume
To play audio from your television through your
home theater system
Preparation
Connect your equipment referring to “Connect to the
various television terminals” (
\
page 11).
Press [EXT-IN] to select “AV” as the source. Then
reduce the volume on the television to its minimum,
and control the volume on this main unit.
Note
• The remote control may not work properly with
some models.
• You can enjoy 5.1-channel surround sound when
you turn on Super Surround (MOVIE, MUSIC)
(
\
page 31).
Operating the cable TV box, digital broadcasting or satellite receiver
This unit can decode the surround signals received
through cable TV box, digital broadcasting or satellite
broadcasts. Refer to your equipment’s operating
instructions for details. Only Dolby Digital and PCM
can be played with this connection.
To DIGITAL OUT
Optical digital audio cable
(not included)
• Do not bend sharply when connecting.
OPTICAL
IN
Rear panel of
this main unit
To select “D-IN” (Digital In) as the source, press
several times.
USB AV AUX
D-IN
(Digital In)
MUSIC P.
When you select “D-IN” as the source, you
can select the following sound effects.
(These
functions only work with Dolby Digital or PCM,
excluding Audio Mode, which only works with Dolby
Digital Dual Mono.)
PCM FIX Mode
Press and hold
[
3
]
.
(remote control)
PFIX ON
: Select when receiving only PCM signals.
PFIX OFF
(factory preset): Select when receiving
Dolby Digital and PCM
signals.
Dynamic Range Compression
Press and hold [
2
].
DRC ON
: Adjusts for clarity even when the volume
is low by compressing the range of the
lowest sound level and the highest sound
level. Convenient for late night viewing.
(Only works with Dolby Digital)
DRC OFF
(factory preset)
Audio Mode
Press and hold
[
5
]
AUDIO ST, AUDIO L, AUDIO R
(“AUDIO L” and
“AUDIO R” only appear when the signal is Dolby
Digital Dual Mono.)
Dolby Pro Logic
II
(
\
page 32)
Press [
Ÿ
PL
II
].
Note
Audio that is input through the OPTICAL IN terminal
cannot be output through the HDMI terminal.
Operating other equipment (continued)
RQTX0059-B_Out_new6.indd 38
RQTX0059-B_Out_new6.indd 38
3/5/07 3:27:17 PM
3/5/07 3:27:17 PM