Others
56
LSQT0860
Before requesting repair
(Problems and solutions)
Power/Body
1: The Camcorder power cannot be turned on.
• Is the battery fully charged? Use a fully
charged battery.
• The battery protection circuit may have
operated. Attach the battery to the AC adaptor
for 5 to 10 seconds. If the Camcorder still
cannot be used, the battery is faulty.
2: The Camcorder power is turned off
automatically.
• If you set [POWER SAVE] to [5 MINUTES] and
do not operate the Camcorder for about
5 continuous minutes, the power is
automatically turned off for tape protection and
power conservation. To resume recording, turn
the [OFF/ON] switch to [OFF]. Then turn it to
[ON] again. (
-25-
)
3: The Camcorder power does not stay on
long enough.
• Is the battery low? If the remaining battery
power indication is flashing or the message
“LOW BATTERY” is displayed, the battery has
run down. Charge the battery or attach a fully
charged battery. (
-14-
)
• Has condensation occurred? When you carry
the Camcorder from a cold place into a warm
place, condensation may occur inside it. If so,
the power is turned off automatically, disabling
all operations except for taking cassettes out.
Wait until the condensation indication
disappears. (
-59-
)
4: Battery runs down quickly.
• Is the battery fully charged? Charge it with the
AC adaptor. (
-14-
)
• Are you using the battery in an extremely cold
place? The battery is affected by ambient
temperature. In cold places, the operating time
of the battery becomes shorter.
• Has the battery worn out? The battery has a
limited life. If the operating time is still too short
even after the battery is fully charged,
depending on the usage, the battery has worn
out and can no longer be used.
5: The Camcorder cannot be operated though
powered up.
The Camcorder does not operate normally.
• Remove the cassette and then press the
[RESET] button. (
-59-
) If normal conditions are
not restored yet, turn off the power. Then,
about 1 minute later, turn on the power again.
(Conducting the above operation when the
access lamp is on may destroy the data on the
card.)
≥
Scene mode
≥
When setting the [AUTO/
MANUAL/FOCUS] switch
to [AUTO]
≥
When the MagicPix
function is used
≥
Change of
white balance
≥
When digital zoom (10
k
or higher) is used
≥
When the MagicPix
function is used
≥
When a menu is
displayed
≥
Adjusting the
shutter speed,
iris/gain
≥
When the MagicPix
function is used
≥
When the scene mode is
used
≥
Variable-speed
search
≥
During repeat playback
≥
Deleting files
≥
When the write protect
switch on the card is set
to [LOCK]
≥
When the file is protected
≥
Formatting
≥
When the write protect
switch on the card is set
to [LOCK]
≥
Audio dubbing
≥
The section of a tape
recorded in LP mode
≥
The blank section of a
tape
≥
Sounds sent through the
DV terminal
LSQT0860ENG.book 56 ページ ２００５年８月１８日 木曜日 午前１１時４３分
