Chapter 2
Getting Started — Connecting
50 - ENGLISH
For <SDI IN 1>/<SDI IN 2> terminals
SD-SDI signal, HD-SDI signal, or 3G-SDI
signal
Digital VCR for commercial use
Note
f
Use the [PICTURE] menu
→
[SYSTEM SELECTOR] to switch the input format.
f
Some external devices to be connected require the [DISPLAY OPTION] menu
→
[SDI IN] to be set.
f
Use a 5CFB or higher (such as 5CFB, or 7CFB) or a Belden 1694A or higher connection cable to properly transmit images. Use a
connection cable of 100 m (328'1") length or less.
f
To input the dual link signals, setting [SDI LINK] in [SDI IN] is required.
f
To input the dual link signals, the cables to connect to the <SDI IN 1>/<SDI IN 2> terminals should be the same length and the same type.
The image may not be displayed correctly when the difference of the cable length is 4 m (13'1") or more.
f
Directly connect the projector with the external device that will output the signal without going through a distributor, etc., when inputting
dual link signals. A phase difference is generated between the LINK-A signal and the LINK-B signal, and the image may not be displayed
correctly.
f
When an unsteady signal is connected, an error in signal detection may occur. In such a case, use the [PICTURE] menu
→
[SYSTEM
SELECTOR] to switch to a system that matches the signal format.
Connecting example: Computers
Control computer
Computer
Computer
Computer
Computer
Control computer
Attention
f
When connecting the projector to a computer or an external device, use the power cord supplied with each device and commercially
available shielded cables.
Note
f
When entering DVI-D, it may be necessary to switch the setting using the [DISPLAY OPTION] menu
→
[DVI-D IN]
→
[EDID SELECT]
depending on the external device to be connected.
f
For the HDMI cable, use an HDMI High Speed cable that conforms to the HDMI standards. If a cable that does not conform to the HDMI
standards is used, images may be interrupted or may not be displayed.
f
The <HDMI IN> terminal of the projector can be connected to an external device equipped with a DVI-D terminal using an HDMI/DVI
conversion cable. However, this may not function properly for some external devices, and images may not be displayed.
f
The <DVI-D IN> terminal supports single links only.
f
When entering the SYNC ON GREEN signal, do not enter sync signals to the <SYNC/HD> terminal or the <VD> terminal.
f
If you operate the projector using the computer with the resume feature (last memory), you may have to reset the resume feature to operate
the projector.
