Panasonic PT-MZ17K, Руководство по эксплуатации, Страница: 258 / 280

Chapter 7 Appendix — Technical information
258 - ENGLISH
Command transmission method
Transmit using the following command formats.
r
Transmitted data
Header Data section
Termination
symbol
Command
example
‘0’
0x30
‘0’
0x30
Control command
(ASCII string)
(CR)
0x0d
Data length 1 byte 1 byte Undefined length 1 byte
f
Example: Transmission of power supply status acquisition command
“00QPW” (CR)
r
Received data
Header Data section
Termination
symbol
Command
example
‘0’
0x30
‘0’
0x30
Control command
(ASCII string)
(CR)
0x0d
Data length 1 byte 1 byte Undefined length 1 byte
f
Example: The projector is in standby status
“00000” (CR)
r
Error response
String Details
Termination
symbol
Message
“ERR1” Undefined control command
(CR)
0x0d
“ERR2” Out of parameter range
“ERR3” Busy state or no-acceptable period
“ERR4” Timeout or no-acceptable period
“ERR5” Wrong data length
Data length 4 bytes ― 1 byte
Note
f
The projector will automatically disconnect the connection with the network right after sending the command. This is the specification based
on the security view point to prevent unauthorized operation of this product by a malicious third party. To send commands continuously,
execute the network connection request every time the command is to be sent. For details, refer to “Communication flow between server
and client” (
x
page 258).
Communication flow between server and client
To send/receive a command via LAN, refer to the communication flow indicated below.
Server : Projector
Client
: Control device such as a computer
Connection request
Server Client
Sending of key
Sending of command 1
Responding to command 1
Disconnection
Connection request
Sending of key
Sending of command 2
Responding to command 2
Disconnection
Session 1
Session 2