Panasonic PT-MZ17K, Руководство по эксплуатации

Страница: 145 / 280

Chapter 4 Settings — [PROJECTOR SETUP] menu
ENGLISH - 145
5) Press
as
to select [GROUP].
6) Press
qw
to switch the item.
[A] - [Z]
Controls multiple projectors simultaneously by sending the ID of RS-232C. You can set groups from
[A] to [Z]. The projector responds when the ID of RS-232C matches the setting.
7) Press
as
to select [RESPONSE(ID GROUP)].
8) Press
qw
to switch the item.
[ON]
Returns the response when an ID is designated as GROUP.
[OFF] Does not return the response when an ID is designated as GROUP.
Note
f
When [INPUT SELECT] is set to [DIGITAL LINK], communication using that serial terminal is available only when the corresponding device
(such as the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G)) is connected to the <DIGITAL LINK>
terminal.
f
When transferring logos via the optional DIGITAL LINK output supported device (Model No.: ET-YFB100G, ET-YFB200G), setting for “NO
SIGNAL SLEEP” of the DIGITAL LINK output supported device should be set to “OFF” to avoid interruption of communication.
f
When [INPUT SELECT] is set to [DIGITAL LINK], communication speed for input is fixed to 9 600 bps and the parity is fixed to “NONE”.
[REMOTE1 MODE]
Set the <REMOTE 1 IN> terminal.
1) Press
as
to select [REMOTE1 MODE].
2) Press
qw
to switch the item.
f
The items will switch each time you press the button.
[DEFAULT]
Uses pin assignment of the <REMOTE 1 IN> terminal in standard setting. (
x
page 263)
[USER] Changes the setting of the <REMOTE 1 IN> terminal.
f
Proceed to Step 3) when [USER] is selected.
3) Press the <ENTER> button.
4) Press
as
to select one from [PIN2] to [PIN8], and press
qw
to switch the setting.
[FUNCTION BUTTON]
Set the function of the <FUNCTION> button on the remote control.
1) Press
as
to select [FUNCTION BUTTON].
2) Press the <ENTER> button.
f
The [FUNCTION BUTTON] screen is displayed.
3) Press
as
to select a function.
[DISABLE]
Disables the <FUNCTION> button.
[SUB MEMORY] Displays the sub memory list. (
x
page 160)
[SYSTEM SELECTOR]
Switches the [SYSTEM SELECTOR] setting according to the input signal of the image being
projected.
f
When the input signal is anything other than the SDI input
The [PICTURE] menu
→
[SYSTEM SELECTOR] (
x
page 92)
f
When the input signal is the SDI input
The [DISPLAY OPTION] menu
→
[SDI IN]
→
[SYSTEM SELECTOR] (
x
page 114)
[SYSTEM DAYLIGHT VIEW] Switches the [SYSTEM DAYLIGHT VIEW] setting. (
x
page 88)
[FREEZE]
Freezes the image temporarily. (
x
page 123)
[WAVEFORM MONITOR]
Displays the waveform of the input signal. (
x
page 123)
[LENS MEMORY LOAD] Loads the registered lens memory. (
x
page 126)
[ASPECT] Switches the aspect ratio of the image. (
x
page 94)
[PROJECTION METHOD]
Switches the [PROJECTION METHOD] setting. (
x
page 125)
[GEOMETRY]
Switches the [GEOMETRY] setting. (
x
page 96)
4) Press the <ENTER> button.