E
NGLISH - 41
Settings
PROJECTOR SETUP menu
You can see the status of the projector about the
following items.
You can switch the function of the
COMPUTER2 IN/
1 OUT
terminal.
INPUT
COMPUTER2 IN
OUTPUT
COMPUTER1 OUT
You can set the timer to switch off the power of the
projector after a certain period of time automatically
when no signal is detected. Press
I
H
to select the
required period from 15 to 60 minutes at intervals of
5 minutes.
You can select how the projector start when the power
cord is connected.
STATUS
Items
Description
Q
SIGNAL
NAME
Projecting signal name
FREQUENCY
Projecting signal frequency
Q
RUNTIME
PROJECTOR
Duration of projector used time
LAMP
Duration of lamp used time
Q
REMAINING FILTER
QUANTITY
Quantity of filter remaining
APPROX.TIME
Approximately time of filter
remaining
NOTE:
•
QUANTITY
and
APPROX.TIME
of
REMAINING
FILTER
is not the accurate but the calculated and
predicted result based on the filter rolling pace.
Incorrect remaining time could be displayed briefly;
such as suddenly shortened or stays same for a while.
• Replacement of the Auto Cleaning Filter (ACF) needs
to be prepared when the
QUANTITY
and
APPROX.TIME
of
REMAINING FILTER
becomes few.
Remote control
Control panel
See “Navigating through the menu” on page 32.
See “Main menu and Sub-menu” on page 30.
COMPUTER2 SELECT
NO SIGNAL SHUT-OFF
DISABLE
FG
FG
15 MIN.
60 MIN.
FG
FG
20 MIN.
55 MIN.
FG
FG
25 MIN.
50 MIN.
FG
FG
30 MIN.
45 MIN.
FG
FG
35 MIN.
IH
40 MIN.
INITIAL START UP
Options
Description
LAST MEMORY
Start as the same mode as the
last switched off.
STANDBY
Always start in standby mode.
ON
Always start in projecting
mode.
Содержание PT-FW300U - LCD Proj Wxga 600:1 3500 Lumens Enet 13.7LBS H/v Lens
Страница 71: ......
