Chapter 4
Settings — [NETWORK] menu
ENGLISH - 135
7) When the confirmation screen is displayed, press
qw
to select [OK], and press the <ENTER> button.
Note
f
The projector does not support 10BaseT Full/Half.
When the projector is connected to a twisted-pair-cable transmitter
1) Press
as
to select [DIGITAL LINK SETUP].
2) Press the <ENTER> button.
f
The
[DIGITAL LINK SETUP]
screen is displayed.
3) Press
as
to select [DUPLEX(DIGITAL LINK)].
4) Press
qw
to switch the communication method.
f
The items will switch each time you press the button.
[100BaseTX-Full]
Full duplex communication method is set.
[100BaseTX-Half]
Half-duplex communication method is set.
[AUTONEGOTIATION]
The communication method is set automatically.
5) Press
as
to select [STORE].
6) Press the <ENTER> button.
7) When the confirmation screen is displayed, press
qw
to select [OK], and press the <ENTER> button.
[DIGITAL LINK STATUS]
Display DIGITAL LINK connection environment.
1) Press
as
to select [DIGITAL LINK STATUS].
2) Press the <ENTER> button.
f
The
[DIGITAL LINK STATUS]
screen is displayed.
[LINK STATUS]
Either [NO LINK], [DIGITAL LINK], or [ETHERNET] is displayed.
[HDCP STATUS]
Either [NO SIGNAL], [OFF], or [ON] is displayed.
[SIGNAL QUALITY]
[SIGNAL QUALITY] is a numerical value of the amount of error, and the display color changes to
green, yellow, or red depending on that value.
Check the signal quality level while receiving a signal from the twisted-pair-cable transmitter.
f
MAX/MIN: Maximum/minimum value of the amount of error.
f
Green (-12 dB or lower)
→
Normal signal quality level.
f
Yellow (-
11 to
-8 dB)
→
Warning level where there is the possibility of noise introduced on the
screen.
f
Red (-7 dB or higher)
→
Abnormal level where synchronization may be interrupted, or a signal may
not be received.
[NETWORK SETUP]
Perform the initial setting of the network before using the network function.
1) Press
as
to select [NETWORK SETUP].
2) Press the <ENTER> button.
f
The
[NETWORK SETUP]
screen is displayed.
3) Press
as
to select an item, and change the settings according to the operation instructions of the
menu.
[PROJECTOR NAME]
Change the setting when using a DHCP server.
[DHCP]
Set to [ON] when obtaining an IP address automatically using a DHCP server. Set to [OFF] when not
using a DHCP server.
[IP ADDRESS]
Enter the IP address when not using a DHCP server.
[SUBNET MASK]
Enter the subnet mask when not using a DHCP server.
[DEFAULT GATEWAY]
Enter the default gateway address when not using a DHCP server.
[STORE]
Save the current network settings.