- 7 -
Important : EMC-cable gland is used for Sensor.
Again, when wiring. Figure.10. becomes points of wiring.
Sensor
Substrate fixing
screw
COM NO NC
(1)Power supply
(2)Alarm contact (SPDT）
(3)Upper limit 1 contact (SPDT）
(4)Upper limit 2 contact (SPDT)
(5)4-20mA (Analog output signal)
※Please earth the terminal FG.
（
3
）
（
2
）
（
1
）
（
4
）
（
5
）
To cable grand
White/Brown/Black/Green/Yellow
Exclusive line
Shilded cable
Transducer
Line-connecting terminal：
Max. 1.5mm
2
Fig.9. Connection
!
(Component part)
Packing
Body
Shield-ring
Rubber bush
Clamping member
Cap
(2)
Completion drawing
(1)
85
(3)
5
(4)
Packing
(1)
Please pass Cap, Clamping member, and Rubber
bush through the cable.
Please peel off the cable covering from
the verge by the length of 85mm.
(2)
Please make the shield line asunder.
Please wrap an asunder shield line
as shown in left figure.
(3)
Please pass Shield-ring through the cable.
Please peel off the cover of the core wire by 5mm.
Please use solderless terminal with insulating
coating of Stick-type by three (brown, yellow, and
white) core wires.
A green core wire must use the pressure terminal of
R type(R1.25-4).
(4)
Please pass Body and Packing through the cable, and
install it so that the shield line may surely come
in contact with the Shield-ring.
Fig.10. becomes points of wiring.
