Panasonic Panafax UF-9000, Руководство по обслуживанию

Страница: 134 / 375

134
UF-9000
APR 2006
Ver. 3.0
DP-180/190
630 XMT or RCV
(Polling)
B Redial count over. No dial tone detected. Sensor dial tone
is not detected. (destination dependent)
Busy tone is detected. (destination
dependent) T1 timer (35 ± 5 sec.)
elapsed without a signal from the
receiver.
631 XMT A "STOP" button was pressed during
Auto Dialing.
634 XMT B Redial count over with no
response or busy tone was not
detected.
Note:
U.S.A. and Canadian models
will redial only once if a busy
tone is not detected.
Telephone line cable is disconnected.
Wrong number is dialed.
SC or FXB PCB is abnormal.
638 XMT LAN Power turned Off with applicable
data in memory or during
communication.
Power switched off.
Power failure occurred.
700 XMT
RCV
PSTN
LAN
Communication terminated by
Operator pressing the "STOP" key.
711 RCV LAN Incorrect LDAP settings. LDAP Server Name, LDAP Login
Name, LDAP Password and/or LDAP
Search Base are incorrect.
712 XMT LAN Unknown email address replied
from the Mail Server.
Mail Server received an incorrect email
address. (Dependent on Server's Mail
application)
714 XMT
RCV
LAN LAN Interface error.
Cannot logon to the LAN.
The 10Base-T/100Base-TX cable is not
connected.
An unexpected LAN problem occurred.
Check the SC PCB connector.
715 XMT LAN TCP/IP connection timed out. Incorrect IP Address is set.
Verify the IP Address, Default Router IP
Address, SMTP Server IP Address.
716 XMT LAN Cannot logon to the LAN. Incorrect SMTP Server IP Address is
set.
No email application is activated on the
Mail Server.
717 XMT LAN Incomplete SMTP Protocol
transmission.
Mail Server’s hard disk may be full.
Mail Server is defective.
718 XMT LAN Page Memory Overflow occurred
while receiving printing data. The
paper size selected within your
application to print is larger than
the paper size loaded in the
Tray(s).
Check the document size and
resolution.
Ask originator to re-send in a supported
size and resolution.
719 RCV LAN Received data via LAN is in a
format that is not supported.
Ask the originator to re-send with a
supported file attachment:
* In a TIFF-F format.
* Image data conforming to A4/Letter
size.
720 POP LAN Unable to connect with the POP
Server.
Incorrect POP Server address is set.
POP Server is down.
Fax Information Codes
Code Mode Phase Description of Problem Cause