Panasonic Panafax UF-490, Руководство по обслуживанию

Страница: 122 / 162

122
032 V34 TX START 2400-33600bps Selects the transmission modem start speed for V.34
communication, 33600-2400 bps.
033 V34 RX START 2400-33600bps Selects the receiving modem start speed for V.34
communication, 33600-2400 bps.
034 V34 TX Symbol
Rate
2400-3429sr Selects the transmission symbol rate for V.34, 3429/
3200/3000/2800/2400 sr.
Press “V” or “/\ “ to select the symbol rate.
035 V34 RX Symbol
Rate
2400-3429sr Selects receiving symbol rate for V.34, 3429/3429/
3200/3000/2800/2400 sr.
Press “V” or “/\ “ to select the symbol rate.
036 Not Used
037 PROTOCOL
DISPLAY
1 = Off (not displayed)
2 = On (displayed) Selects whether to display the modem speed during
communication.
(Press the Job Status Key to display)
038 Not Used
039 FLASH TIME 5 = 50 ms
~
100 = 1000 ms Selects the pause interval before activating the Flash
key.
040 E/F TIME
(Except for USA
and Canada)
5 = 50 ms
~
100 = 1000 ms Selects the pause interval before activating the Flash
key.
041 PAUSE TIME 1 = 1 sec.
~
10 = 10 sec. Selects the pause interval from 1 sec. ~ 10 sec. for
dialing through a switchboard or for international
calls.
042 Not Used
043 REDIAL
INTERVAL
0 = no waiting
~
15 = 15 minutes Selects the redial interval from 0 to 15 minutes in 1
minute steps.
044 REDIAL COUNT 0 = no redial
~
15 = 15 times
Selects the redial count from 0 to 15 times in 1 step
intervals.
Note:
In order to comply with the requirements TBR21 in
the EC countries, do not select 15 times.
045 RING DETECT
COUNT
1 = 1 ring
~
9 = 9 rings Selects the ring detection count from 1 to 9 rings in 1
ring step intervals.
046 ON-HOOK TIME 0 = 0 sec.
~
90 = 90 sec.
Selects the on-hook time between sequential
communication calls in 1 second step intervals.
047 RESPONSE
WAIT
1 = 1 sec.
~
90 = 90 sec. Selects the waiting interval for the response after
completing the dialing.
048
049 Not Used
050 RING DETECT
MODE
1 = Normal
2 = Rough Selects the quality of ringer detection. Use if the line
signal is out of regulation, set to "Rough" so that the
unit may detect the ringing signals.
051 Not Used
052 PULSE RATE 1 = 10 pps
2 = 20 pps Selects the dial pulse rate 10/20 pps.
Function Parameter Table
No. Parameter Selections Function