Panasonic NN-SM221WZTE, Руководство по эксплуатации

Страница: 4 / 94

Examine your microwave oven
Unpack the oven, remove all packing material,
and examine the oven for any damage such as
dents, broken door latches or cracks in the
door. If you find any damage, notify your dealer
immediately. Do not install a damaged
microwave oven.
Earthing instructions
IMPORTANT: THIS UNIT HAS TO BE
PROPERLY EARTHED FOR PERSONAL
SAFETY.
personal responsibility of the customer to have
socket.
Operation voltage
The voltage has to be the same as specified
on the label on the oven. If a higher voltage
than specified is used, it may cause a fire or
other damages.
Placement of the Oven
This oven is intended for household
countertop use only. It is not intended for
built-in use or use inside a cabinet.
1. Place the oven on a flat and stable
surface, more than 85 cm above the floor.
2. When this oven is installed, it should be
easy to isolate the appliance from the
electricity supply by pulling out the plug or
operating a circuit breaker.
3. For proper operation, ensure a sufficient air
circulation for the oven.
Counter-top use:
a.
opened more than 40 cm.
b. If one side of the oven is placed flush
to a wall, the other side or top must
not be blocked.
4. Do not place this oven near an electric or
gas cooker range.
5. The feet should not be removed.
6. This oven is only for household usage.
Do not use outdoors.
7. Avoid using the microwave oven in high
humidity.
8. The power cord should not touch the
outside of the oven. Keep the cord away
from hot surfaces. Do not let the cord hang
over the edge of a table or work top. Do not
immerse the cord, plug or oven in water.
9.
back of the oven. If these openings are
blocked during operation the oven may
overheat. In this case the oven is protected
operation only after cooling down.
10. This appliance is not intended to be
10 cm
OPEN
Counter-top
Installation and Connection
15 cm
5 cm
Allow 15 cm of space on the top of
one side, and the other side must be
the oven, 10 cm at the back, 5 cm on
If your AC outlet is not earthed, it is the
it replaced with a properly earthed wall
by a thermal safety device and resumes
operated by means of an external timer or
separate remote-control system.
Do not block the air vents on the left and
En-2