20
SUBSEQUENT TRANSPORT
MOVING AND TRANSPORT
510549
After each drying cycle, a small amount of condensed water
will remain in the pump section. Switch on the appliance and
choose one of the programmes, then let the appliance operate
for approximately half a minute. This will pump out the remaining
water and prevent damage to the dryer during transport.
If the appliance was not transported in compliance with the
instructions, the dryer should be left to stand still at least two
hours before it is reconnected to the power mains. Failure
to do so may result in a heat pump failure which shall not be
covered by the warranty.
Be careful not to damage the cooling system.
If the dryer cannot be transported in the upright position, tilt it to the left side.
After transport, the dryer should be left to stand still for at
least two hours before it is connected to the power mains to
allow the system to stabilise. We recommend that installation
and connection should be done by a qualified person.
The belt should only be replaced by a service engineer, using
an original spare part.
NH-P8ER1_WGB_En.indd 20
2015/08/24 10:55:55
