Panasonic NB-DT52, Руководство по эксплуатации

Страница: 4 / 26

English
Note
Slide-out crumb tray
● Insert it toward the far end securely.
(If it is not properly set, it may result in poor cooking.)
● Pull it toward you to remove. (after the body cools down)
● The crumb tray should be cleaned regularly. Do not use it when it is dirty.
(P. EN23)
(Otherwise, crust colour of toast bottom may be light.)
Door
●
Do not open the
door during cooking.
(It may affect the
browning)
Lower heater
Upper heaters
● Covered with protective cover to prevent possible touching
heater.
(
The heaters might damage
)
● Near-infrared ray heater (far end)
(
Also serves as lighting.)
● Far-infrared ray heater (door side)
(
Will not light up even it is powered on.)
Power plug
Heat vent
Rack hook
● Hangers should be proper
installed to avoid any danger
arising from a falling door.
(P. EN23 )
Glass window
● Do not spray water on
it if it is hot
.
(The glass
might break.)
●
Clean up the surface
chippings before closing
.
Power cord
Preset Cooking Modes (P. EN8-EN16) Set the crust colour and heating intensity
(Light/Slightly Light/Standard/Slightly Dark/Dark)
●
For baking frozen toast, croissant and pizza
(P. EN8 - EN11)
Power Off/On
● Press to turn on
(power lamp comes on).
● Press to turn off during operation (power lamp goes out).
● Press after use to disconnect
(power lamp goes out
）
Set the temperature
(manual mode)
Set the cooking time Power lamp Timer (manual mode)
(P. EN17)
Door handle
Oven rack
(detachable, P. EN23)
Oven tray
● Place onto the oven rack.
•
The grooved surface makes the tray more efficiently in "Fried
Food Reheat" and other cooking modes.
(The food might get groove
patterns on its bottom)
•
Place a sheet of aluminum foil on the oven tray to prevent stain.
It is advisable to put a sheet of aluminum foil on the tray, pressing it
with fingers along the grooves to ensure that frozen pizza or cold fried
food can be crispy cooked.
•
During cooking, the oven tray might warp due to internal temperature
effect, but it can restore original shape after cooling down.
Even spread of ingredients may reduce warping phenomenon.
Control panel label
Sticking position:
Refer to the directions on
the “Control panel label”.
Heater protective cover
Parts Names and Handling Instructions
Body
Accessory
Control Panel
●
The microcontroller automatically turns heaters on and off to adjust the temperature
during cooking.
(Even if the heater is turned off, this is not a malfunction)
● At baking temperature (of 120 - 140), heater may remain switched off for about 3 minutes, which is
not abnormal.
● It smells when using the appliance initially, but it will not smell after repeated using.
● During cooking, smoke and vapor from ingredients may get out from the gap between body and
door. Discolouration may be found around the door and on the body
.
EN6 EN7