Panasonic Lumix DMC-L10, Руководство по эксплуатации, Страница: 71 / 160

Advanced
71
VQT1G28
Taking Pictures using
Burst Mode
1
Set the drive mode lever to [ ].
A
When burst mode is set to high speed
[H].
2
Focus on the subject and take a
picture.
• Hold down the shutter button fully to
activate the burst mode.
∫
Changing the burst speed
1
Press [MENU/SET] to display the
menu.
2
Press
3
/
4
/
2
/
1
to select
[BURST RATE] in the [REC] menu
[
] and then press
1
.
3
Press
3
/
4
to select [H] (High
speed) or [L] (Low speed) and
then press [MENU/SET].
• You can also use the front dial or the
rear dial to select a menu item.
4
Press [MENU/SET] to close the
menu.
• You can also press the shutter button
halfway to close the menu.
∫
Burst speed
• The burst speed is constant regardless of
the transfer speed of the card.
• The burst speeds indicated are when the
shutter speed is faster than 1/60 and the
flash is not activated.
• The burst mode speed may become
slower depending on the following
settings.
– ISO sensitivity (P78)
– Picture size (P94)
– Quality (P94)
– Focus priority (P106)
– Focus mode
• Since the shutter speed becomes slower
in dark places, the burst speed (pictures/
second) may become slower.
∫
Number of pictures recorded in burst
mode
• Refer to P94 for information about RAW
files.
• When there are no RAW files, pictures
can be taken until the capacity of the card
becomes full. However the burst speed
will become slower halfway. The exact
timing of this depends on the picture size,
the setting for [QUALITY] and the type of
card used.
A
MENU
/SET
(High) (Low)
Burst speed
(pictures/
second)
3 2
With RAW files
Without RAW
files
Number of
recordable pic-
tures (pictures)
max. 3
Depends on
the remaining
capacity of the
card
VQT1G28ENG_L10KP.book 71 ページ ２００７年９月６日 木曜日 午前９時２９分