Error messages
Display message
Cause/solution
Base no power
or
No link to base.
Reconnect main
base AC adaptor.
or
No link.
R
The handset has lost communication with the base unit. Move
closer to the base unit and try again.
R
Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
R
The handset’s registration may have been cancelled.
Re-register the handset (page 44).
R
When
“
No link.
”
is displayed during a power failure, place
a handset on the base unit to supply power to the base unit.
Check
Phone Line
R
The supplied telephone line cord has not been connected yet
or not connected properly. Check the connections (page 8).
R
If you do not connect the telephone line cord and use only
mobile lines, set the mobile line only mode (page 18).
Error
R
Recording was too short. Try again.
R
Someone is using a mobile line or headset. Try again later.
R
The phonebook copy is incomplete (page 48). The mobile
phone is disconnected from the base unit. Make sure that
other Bluetooth devices are not connected to the mobile
phone, and try again.
Failed
R
Although the unit tried to connect to the mobile phone or
headset, the connection has been failed.
– Someone is using a mobile line or headset. Try again later.
– Make sure that the mobile phone or headset is not
connected to other Bluetooth devices.
Memory Full
R
The phonebook memory is full. Erase unwanted entries
(page 28).
R
Message memory is full. Erase unwanted messages
(page 53, 54).
R
The call block list memory is full. Erase unwanted entries
(page 41).
Use
rechargeable
battery.
R
A wrong type of battery such as Alkaline or Manganese was
inserted. Use only the rechargeable Ni-MH batteries noted on
page 3, 6.
You must first
subscribe
to Caller ID.
R
You must subscribe to a Caller ID service. Once you receive
caller information after subscribing to a Caller ID service, this
message will not be displayed.
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s
AC adaptor and turn off the handset, then reconnect the base unit’s AC adaptor and turn on the
handset.
61
Useful Information
TGH260BX_UE(en)_0806_ver021.pdf 61
2014/08/06 15:12:51