restricted units from dialling any phone number in
that area code.
Handset / Base unit
1
M
MENU
N#256
2
Enter the base unit PIN (default:
“
0000
”
).
R
If you forget your PIN, see page 52.
3
MbN
: Selected the desired units to be
restricted.
a
M
SELECT
N
R
“ ” is displayed next to the selected
numbers.
R
To cancel the selected unit:
MbN
: Select the
unit.
a
Press
M
SELECT
N
again. “ ”
disappears.
4
M
OK
N
5
Select a memory location by pressing
1
to
6
.
a
M
OK
N
6
Enter the phone number or area code to be
restricted (8 digits max.).
a
M
OK
N
7
Proceed with the operation for your unit.
Handset:
M
OFF
N
Base unit:
M
EXIT
N
Enhancing security for phone calls
You can increase the security of phone
conversations by setting this feature to
“
Enhanced
”
. When
“
Enhanced
”
is selected,
is displayed. The default setting is
“
Normal
”
.
Handset / Base unit
1
M
MENU
N#729
2
MbN
: Selected the desired setting.
a
M
OK
N
3
Proceed with the operation for your unit.
Handset:
M
OFF
N
Base unit:
M
EXIT
N
Note:
R
If you set repeater mode to
“
On
”
(page 38):
– Security is set to
“
Normal
”
and is
displayed.
–
“
Security
”
is not displayed in the display
menu (page 31).
R
When enhanced security is enabled, sound may
cut in and out during conversations.
Changing the base unit PIN
Important:
R
If you change the PIN (Personal Identification
Number), please make note of your new PIN.
The unit will not reveal the PIN to you. If you
forget your PIN, see page 52.
Handset / Base unit
1
M
MENU
N#132
2
Enter the current 4-digit base unit PIN (default:
“
0000
”
).
3
Enter the new 4-digit base unit PIN.
a
M
OK
N
4
MbN
:
“
Yes
”
a
M
OK
N
5
Proceed with the operation for your unit.
Handset:
M
OFF
N
Base unit:
M
EXIT
N
Registering a unit
Operating additional units
Additional handsets
Up to 6 handsets can be registered to the base
unit.
Important:
R
The additional handset model recommended for
use with this unit is noted on page 4. If another
handset model is used, certain operations may
not be available.
Registering a handset to the base unit
The supplied handset and base unit are
pre-registered. If for some reason the handset is
not registered to the base unit (for example, is
displayed even when the handset is near the base
unit), re-register the handset.
1
Handset:
M
MENU
N#130
2
Base unit:
Press and hold
M
N
for about 5 seconds.
R
If all registered handsets start ringing, press
M
N
again to stop, then repeat this step.
Helpline Tel. No.: U.K. 0844 844 3899 Ireland 01289 8333
37
Programming
TGF320E(en)_0123_ver020.pdf 37
2015/01/23 18:26:30
