Useful Information
40
Error messages
If the unit detects a problem, one of the following messages is shown on the display.
Display message
Cause/solution
Base no power
or
No link to base.
Reconnect main
base AC adaptor.
L
The handset has lost communication with the base
unit. Move closer to the base unit and try again.
L
Unplug the base unit’s AC adaptor to reset the unit.
Reconnect the adaptor and try again.
L
The handset’s registration may have been cancelled.
Re-register the handset (page 29).
Check Phone Line
L
The supplied telephone line cord has not been
connected yet or not connected properly. Check the
connections (page 8).
Invalid Number
L
You tried to send an SMS message to a phone number
saved in the phonebook, caller list, or redial list that is
over 20 digits long.
Memory Full
L
The phonebook memory is full. Erase unwanted
entries (page 19).
L
The call barred list memory is full. Erase unwanted
entries (page 28).
L
The maximum number of base units (4) is already
registered to the handset. Cancel unused base unit
registrations from the handset (page 30).
Use rechargeable
battery.
L
A wrong type of battery such as Alkaline or
Manganese was inserted. Use only the rechargeable
Ni-MH batteries noted on page 4, 6.
You must first
subscribe to
Caller ID.
L
You must subscribe to a Caller ID service. Once you
receive caller information after subscribing to a Caller
ID service, this message will not be displayed.
TG8511_19BX(e).book Page 40 Thursday, July 8, 2010 5:44 PM