Programming
29
2
Enter the base unit PIN (default:
“
0000
”
).
L
If you forget your PIN, contact an
authorised service centre.
3
t
L
Handset registered to the base
unit is displayed.
L
“
Q
” is displayed next to the
handset number.
L
To cancel the handset, press
t
again. “
Q
” disappears.
4
M
5
{V}
/
{^}
: Select a memory location.
i
M
6
Enter the phone number or area
code to be restricted (8 digits max.).
i
M
i
{i
c
}
L
To erase a restricted number,
press
^
.
Note:
L
You can also select a memory location
in step 5 as follows:
Press
{
1
}
to
{
6
}
.
i
M
Registering a unit
Operating additional units
Additional base units
Handsets can be registered to up to 4
base units, allowing you to add
additional base units and extend the
area in which your handset(s) can be
used. If a handset moves out of range of
its base unit when
“
Auto
”
is selected on
base unit (page 29), it looks for another
base unit to make or receive calls. A
base unit and the handsets it
communicates with is called a “radio
cell”.
Note:
L
Calls are disconnected when the
handset moves from one radio cell to
another.
Registering a handset to a
base unit
The supplied handset and base unit are
pre-registered. If for some reason the
handset is not registered to the base unit
(for example,
_
is displayed even when
the handset is near the base unit), re-
register the handset.
1
Handset:
1
(centre of navigator key)
i
{
#
}{
1
}{
3
}{
0
}
2
{V}
/
{^}
: Select a base unit number.
i
M
L
This number is used by the
handset as a reference only.
3
Base unit:
Press and hold
{x}
for about 5
seconds. (No registration tone)
L
If all registered handsets start
ringing, press the same button to
stop. Then repeat this step.
L
The next step must be completed
within 90 seconds.
4
Handset:
Wait until
“
Base PIN
”
is displayed.
i
Enter the base unit PIN (default:
“
0000
”
).
i
M
L
If you forget your PIN, contact an
authorised service centre.
L
When the handset has been
registered successfully,
w
is
displayed.
Selecting a base unit
When
“
Auto
”
is selected, the handset
automatically uses any available base
unit it is registered to. When a specific
base unit is selected, the handset makes
and receives calls using that base unit
TG8511_19BX(e).book Page 29 Thursday, July 8, 2010 5:44 PM
