Panasonic KX-TDE100, Начало работы, Страница: 20 / 32

3.1 Starting the PBX
CAUTION
•
Use only the AC power cord included with the PBX for the PSU.
•
Before touching the System Initialise Switch, discharge static electricity by touching ground or wearing
an earthing strap.
•
Once you have started the PBX and if you unplug the PBX, do not perform the following procedures
to start the PBX again. Otherwise, your programmed data will be cleared.
•
The power supply cord is used as the main disconnect device. Ensure that the AC outlet is located
near the equipment and is easily accessible.
Notice
The SD Memory Card must be inserted in the SD Memory Card slot of the IPCMPR card before startup.
Note
The PBX will continue to be powered even if the power switch is turned "OFF".
1.
Slide the System Initialise Switch to the "SYSTEM INITIALIZE" position.
System Initialise Switch
SYSTEM
INITIALIZE
NORMAL
Power
Supply Unit
RUN Indicator
To AC
Outlet
2.
Plug the AC power cord into the PBX and an AC outlet, and turn on the PBX. The RUN indicator will flash.
3.
While the RUN indicator is flashing, slide the System Initialise Switch back to the "NORMAL" position.
Depending on the configuration, initialisation takes about 1 min to 3 min. If successfully executed, the
RUN indicator will stop flashing and stay lit.
All data will be cleared and the PBX will be initialised to the default values. The DPTs should show the time
as 01:00.
20 Getting Started for Physical Cards
3.1 Starting the PBX
WWW.ERTEBATGROUP.COM
WWW.ERTEBATGROUP.COM