Panasonic KX-P7100, Руководство по обслуживанию

Страница: 39 / 148

Note:
When reinstalling the exit roller rubber to the lower exit roller shaft, ensure it is installed as shown in figure-( A ).
3.11.2. Heat Lamp
(1) Remove the Side Fuser Cover ( 2 screws ).
(2) Remove the screw ( A ) and screw ( B ) from the ends of
Heat Lamp Terminals.
(3) Slide out the Heat Lamp.
Caution:
·
Do not touch the heat lamp with your fingers.
a. It may be hot.
b. The oil and dirt from your fingers will
contaminate the surface, which will result in
damaging the heat lamp when it is turned on.
· When reinstalling the heat lamp, set the terminal
of the heat lamp in the center of the Heat Roller
to prevent from shorting, or shock, fire or other
hazards may occur. {see figure ( A )}
· When reinstalling the Heat Lamp, the terminal
cable must be attached at the rivet side as
shown to fix them certainly. {see figure ( B )}
3.11.3. Heat Roller
(1) Remove the screw and Thermistor.
(2) Remove the Heat Roller Gear and Bushing.
(3) Remove the Heat Roller with care to prevent scratching or
damage to the surface of the Heat Roller.
39
KX-P7100