2.
If a call button is pressed, Pinpon tone rings and the light source LED lights up according to the web
setting, and the status LED starts blinking (Blue 0.25 second on/0.25 second off). In addition, at the IP
Video Doorphone side ring-back tone is audible. (We call this status a Doorphone call).
3.
If the callee answers a call, the callee can monitor the video from the IP Video Doorphone (if the callee
is a Video SIP client).
4.
Pressing Dial Key
on the callee side starts IP Video Doorphone talking (if the callee is a SIP client
that has both video and audio). In this case, the status LED will be on blue.
5.
It is possible to change settings to skip video monitor and immediately to start doorphone talking with
the embedded web menu. Please refer to page 64.
6.
If the callee is an Audio SIP client, the IP Video Doorphone talking starts by answering the doorphone
call without pressing Dial Key
.
7.
If the callee does not answer within the IP Video Doorphone Call ring duration (default: 30 seconds),
the IP Video Doorphone call stops and the light source LED turns off. The status LED turns on green.
8.
If the callee client do not press Dial Key
within the Call ring duration (default: 30 seconds), the IP
Video Doorphone call stops, video monitoring ends, the light source LED turns off and the status LED
turns on green.
9.
If the callee does not press Dial Key
but just hooks on, the Video monitoring finishes. However, the
IP Video Doorphone call continues until the Call ring duration elapses.
10.
From the embedded web menu, you can configure the Communication IP Camera call to end
immediately or to continue calling. Please refer to page 64.
11.
If call button was pressed during Call ring duration, Pinpon tone rings again, Ring back tone restarts
and the Call ring duration timer is reset.
12.
Doorphone answers busy when the Internal line makes a call during the Call ring duration.
13.
If the callee is busy (or cannot answer), a busy tone rings and the status LED keeps blinking (blue 0.25
second on/0.25 second off). PBX rejects the call and does not connect. The doorphone stops calling
after ringing a busy tone for 10 seconds. The busy tone stops immediately when a call button is pressed
during a ringing busy tone.
14.
After pressing a call button again during an internal call, call button operations within a second in length
are ignored. After passing a second from pressing the call button, if a user presses the call button
again, it sounds the Pinpon tone and restarts the Ring back tone.
Next the calling timer for Call ring duration is extended (the duration is from when last pressing the call
button). The same operation will be operated when the called unit is busy.
15.
Outgoing call triggered by an event
•
The following events can trigger outgoing calls. Turn on/off each event with the embedded web
menu.
"Video motion detection"
"Periodically"
"Digital input"
"System boot"
"Recording notify"
"Voice detection"
"Camera tampering detection"
"Manual triggers"
•
Events are ignored during IP Video Doorphone calls or IP Video Doorphone talking.
•
Other operations is the same as triggered by pressing call button.
*1
Call ring duration is variable.
Call ring duration: 10 seconds-150 seconds
Default: 30 seconds
3.
Make a call from Internal line
1.
Users can establish a call with the IP Video Doorphone by dialing internal line numbers assigned to
the IP Video Doorphone.
* Internal line numbers for the IP Video Doorphone can be changed with the embedded web menu.
Please refer to page 61.
32
User’s Manual
1 Operations
