Panasonic KX-NS300, Руководство по установке

Страница: 231 / 300

Setting up KX-UT series SIP phones without connecting to the KX-NS300 at the main site, and
then sending them to the remote site
1.
Log in to the Web Maintenance Console of the site where the SIP phones will be registered.
2.
Click Utility
®
File
®
File Transfer PBX to PC .
3.
Select the config file according to the protocol used and then download it to your PC.
•
HTTP is used
–
UT_ACS_xxyyy.cfg
•
HTTPS is used
–
UT_ACS_HTTPS_xxyyyy.cfg
For more details about downloading files from a PBX to a PC, refer to "7.2.2 Utility—File—File Transfer
PBX to PC" in the PC Programming Manual.
Note
xx: Site ID (2 digits)
yyyy: Site name
*1
(Up to 32 characters
*2
)
*1 Spaces as well as the following characters in site names will be replaced with underscores.
/, :, *, ?, ", <, >, | (vertical bar), &, +
*2
In some cases, the full site name may not be included in the file name even if it is less than 32 characters.
4.
Download the config file to the KX-UT series SIP phone via the Web user interface of the KX-UT series
SIP phone.
For details, refer to "When the SIP Phones are in a different LAN (Remote site installation)" in
"5.7.1 Assigning IP Addressing Information".
5.
Connect the KX-UT series SIP phone to the LAN at the remote site.
6.
Register the KX-UT series SIP phone to the KX-NS300 as a remote extension.
a.
Click Setup
®
PBX Configuration
®
Configuration
®
Slot .
b.
Move the mouse pointer over the V-UTEXT8 card (Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
c.
Click Port Property .
d.
Click Remote Place tab.
e.
Configure the items shown below.
•
Change the value to Remote (SBC) for Phone Location .
•
Change the value to Enable for Web-MC Ability .
•
Select a protocol (HTTP/HTTPS) for Protocol for Remote SIP-MLT .
Note
Select the same value as you selected for NAT - SIP Proxy Server Port No. in step 5 of
"Programming the KX-NS300" in this section.
f.
Click OK .
7.
Register the KX-UT series SIP phone. For details, refer to "5.8.1 Registering IP Telephones".
Note
•
You can select HTTPS for Protocol for Remote SIP-MLT only when Phone Location is set as
Remote (SBC) .
•
If the KX-UT series SIP phones don't work normally, confirm if the KX-UT series SIP phones are able
to access to internet.
Installation Manual 231
5.8.3 Installing SIP Phones at a Remote Site