d.
Plan the location of the CS so that its clock signal source is within range of the CS where the radio signal
strength level is "07".
e.
Make sure that the radio signal strength level is greater than "03" at any location within the service area
required by the user.
4. Finish the site survey
Refer to "6 After Site Survey".
a.
Turn off the PS.
b.
Stop supplying power, and return all DIP switches of each CS to the OFF position.
5. Connect the CS to the PBX
Refer to "7 Connecting IP Cell Stations".
a.
Assign IP address information to the CS using the IP Terminal Maintenance Console.
b.
Connect the CS to the PBX over a LAN.
6. Register the CS to the PBX
Refer to "8 Registering IP Cell Stations".
a.
Register the CS to the PBX using the Maintenance Console.
b.
Assign the Master CSs and set the synchronizing CS search order using the Maintenance Console.
7. Confirm the status of Air Synchronization for the CS
Refer to "9 Confirming the Status of Air Synchronization for IP Cell Stations".
a.
Check the status of air synchronization for the CS using the Maintenance Console.
b.
If the monitoring results are not satisfactory, relocate the CS or change the CS that it is currently
synchronized with to another CS using the Maintenance Console.
8. Connect the PS to the PBX and test the operation
Refer to "10 Registering Portable Stations".
a.
Register the PSs to the PBX.
b.
Walk around the service area while having a conversation using a registered PS. If noise is frequent or
conversations disconnect, relocate the CSs or install an additional CS.
9. Mount the CS on the wall
Refer to "11 Wall Mounting".
a.
If there are no problems in testing, mount the CS on the wall.
Document Version 2009-12
Quick Installation Guide
15
2 Procedure Overview
