Panasonic KX-HCM270, Руководство по эксплуатации

Страница: 123 / 138

Operating Instructions
[For assistance, please call: 1-800-272-7033] 123
When forgetting
the password to
access Setup
Page. Follow the steps below.
1.
Initialize Network Camera by pressing the CLEAR SETTING
button.
2.
Reconfigure Network Camera.
Indicator does
not light up. • Confirm that the standard AC adaptor PSLP1233 (Order No.
PSLP1233Z) is used.
• Confirm that the Indicator Control is disabled. Refer to page 88
for
Indicator Control window .
Indicator is
orange. • Ethernet cable is not connected properly.
• PC, Ethernet hub or broadband router is not working.
Green indicator
continues
blinking. Internal Failure of the server or the congestion on the network
traffic when using DHCP may prevent Network Camera from
getting the IP address. Ask the network administrator or your ISP.
Orange
indicator
continues
blinking. Orange indicator blinks when updating firmware on page 91. When
the Update Firmware failed, refer to page 124.
Red indicator
continues
blinking. If you cannot access Network Camera, the Network Camera
hardware may be defective. Call our customer call center.
Image Transfer
on e-mail or FTP
does not work. • Default Gateway and DNS server address should be set up on
Network window on page 58.
• If FTP does not work properly, ask your ISP or network
administrator about the transferring mode of FTP server.
[Passive Mode] or [Active Mode] is available.
• Select [One Time] for Login Timing when transferring images
by FTP in short duration time.
Timer mode
transfers older
images. Short interval of Image Buffer Frequency makes Network Camera
transfer the older images. Set the interval long enough to transfer
the images. Buffered Image screen enables you to check this
setting.
About Network Camera Setup
Problem Cause and Remedy