23
Before starting the connection, turn off the power of this camera and the devices to be connected.
Check and prepare the required devices and cables for connection.
Connection
12V IN
INITIAL
SET
ACT
LINK
POWER
10BASE-T/
100BASE-TX
LAN cable
(This illustration
represents WV-SP105.)
12V IN
INITIAL
SET
ACT
LINK
POWER
10BASE-T/
100BASE-TX
(This illustration
represents WV-SP105.)
To 12 V DC
power supply
(12 V DC)
(GND)
12 V DC power
cord plug
(accessory)
z
Connect a LAN cable (category 5 or better) to the
network connector on the rear of the camera.
x
Connect the power cord.
Important:
• The 12 V DC power supply shall be insulated from the commercial AC power.
●
When using 12 V DC power supply*
q
Loosen the screw of the power cord plug (accessory).
w
Connect the cable of the 12 V DC power supply* to the
power cord plug.
Strip 3 mm - 7 mm {1/8" to 9/32"} from the end of the
wire, and twist the stripped part of the wire sufficiently to
avoid short circuit.
Specification of cable (wire):
16 AWG - 28 AWG,
Single core, twisted
• Check whether the stripped part of the wire is not
exposed and is securely connected.
e
Tighten the screw of the power cord plug (accessory).
r
Connect the power cord plug (accessory) to the 12 V DC
power supply terminal on the rear of the camera.
* FOR UL LISED MODEL(S), ONLY CONNECT 12 V DC
CLASS 2 POWER SUPPLY.
Caution:
• FOR UL LISTED MODEL(S), ONLY CONNECT 12 V DC CLASS 2 POWER SUPPLY.
