21
Remove the angle adjustment cover
After determining the installation angle of the camera, remove the angle adjustment cover. Make
sure the camera is secured to the camera mount bracket, and place the sticker (accessory) over
the tripod screw hole on which the hook of the angle adjustment cover was put.
Secure the safety wire on the ceiling or wall
Secure the safety wire to the foundation part of the construction or a part with adequate strength
(minimum pull-out strength 196 N {44.06 lbf}).
Prepare the fixing screw according to the material of the area where the safety wire is to be fixed.
For mounting on ceiling, use the safety wire (accessory), washer (accessory) and spring washer
(accessory). For mounting on wall, use a safety wire kit (locally procured).
Important:
• The safety wire shall be adjusted to remove slack.
• Be sure to install the safety wire to prevent a fall of the camera resulting in injury or accidents in
case the camera comes off.
• To prevent the mounting strength from becoming lower, do not use wooden screws to secure
the safety wire.
