Panasonic F-VR401, Руководство по эксплуатации

Страница: 33 / 44

VR401
33
Operating methods
Care and
maintenance
Air filter / Body /
Front panel / Dirt sensor
Care and maintenance
Before cleaning
Be sure to disconnect
the power plug.
●
Do not use the detergent other than the neutral one for
kitchen purpose. (Deterioration, deformation or breakage
of plastic parts may occur.)
●
When using chemically treated cloth, follow its instructions.
Air filter
<about once every 2 weeks>
Suck the front side with vacuum
cleaner etc.
(Installation and removal instructions → P.28)
To remove dust accumulated on the filter area,
suck with vacuum cleaner etc.
Lay the filter on
newspaper etc.
●
Do not apply excessive force because it is easy
to be damaged. (Pay close attention when
cleaning the back side because it is breakable.)
●
Do not wash with water.
Attention
●
Do not operate without the air filter.
(It may make it impossible to obtain the effect
to clean air, or may cause failure due to dusts
entering the product.)
●
Safely keep the parts removed from the
product when cleaning. (Otherwise you may
trip over them. Or the parts may be damaged.)
Body, Front panel
<about once a month>
Wipe with a soft wrung cloth.
(Installation and removal instructions → P.28)
Wiping with hard cloth may scratch the surface.
●
Wipe the power plug with dry cloth.
Reference time for
the air filter replacement
(Service parts P.42)
replacement period
conditions
About once every
5 years
When six cigarettes have
been smoked daily. (Japan
Electrical Manufacturers'
Association JEM1467)
٭ Filter replacement period may be greatly shortened,
depending on the use environment and conditions.
(For example, smoking is frequent.) When the effect
has faded (for example when odor stays longer than
before), replace the filter.
●
After replacement, fill the date installing the
filter in the label and stick it on the back of
the product.
●
Dispose of the used filter as inflammable garbage.
Dirt sensor
<about once every 3 months>
Wipe dirt off the lens with dry cotton swab.
●
Wipe the lens periodically.
(The sensor may not work normally when it is
contaminated with moisture or tar of cigarette.)
Remove the
sensor cover.
Wipe dirt off with
dry cotton swab.
Lens (Upper left)
Dry cotton swab
●
Be sure to disconnect the power plug before cleaning the sensor.
●
Do not insert the cotton swab anywhere other than the lens.
●
Illuminate the area when you do not see clearly.