Troubleshooting
VQT5D92
113
The following messages or service numbers
appear on the unit’s display when something
unusual is detected.
The remote control and main unit are using
different codes. Change the code on the remote
control. (
>
107)
CAM is being updated. (
>
101)
Selected titles in the USB HDD are being
converted.
Do not disconnect the USB HDD from this unit.
TV Guide data is being downloaded.
If there is no change after switching the unit to
standby mode and turning it on, consult the
dealer.
You cannot delete items on this disc.
The disc may be damaged.
• The disc is dirty. (
>
10) The unit cannot record,
play, or edit.
• The lens cleaner has finished cleaning.
Press [
<
OPEN/CLOSE] on the main unit to
eject the disc.
You cannot write to this disc.
The disc may be damaged. Use a new disc.
• Displayed when the unit is started and is
switched to standby mode.
• There was a power failure or the AC plug was
disconnected while the unit was on. The unit is
carrying out its recovery process. Wait until the
message disappears.
There are already 32 timer programmes. Delete
unnecessary timer programmes. (
>
39)
The USB device is drawing too much power.
Remove the USB device.
Update of the software (firmware) is started.
You cannot operate the unit until the update is
complete. (
>
101)
Software (firmware) is downloading.
Download will stop when the unit is turned on, or
the timer recording starts. (
>
101)
The media is not supported.
Messages on the unit’s display
BD
(“
∑
” stands for a number.)
CAM-UP
CONV
GUIDE
HARD ERR
NoERAS
NoREAD
NoWRIT
PLEASE WAIT
PROG FULL
REMOVE
START
SW-DL
UNSUPPORT
DMR-BCT83_73EN_eng.book 113 ページ 2013年7月18日 木曜日 午前10時28分