
49
VQT2J83
Re
fe
re
n
ce
Cannot obtain IP address.
Please check the connection or
setting of the router.
¾
If you use a hub, then check the connection between the hub
and the router.
j
Use the UPLINK port of the hub to connect to a router.
(
>
31)
j
Check whether or not the hub’s Link lamp lights up. If it
does not light up, then check the cable connection, LAN
terminal connection, cable itself (a crossover cable may
have been used by mistake), etc.
¾
If the above conditions are OK, then the router may not
operate in DHCP mode. Check the router settings and
operation. You may reset the router to restore it to normal.
This IP address is already in use.
Please check the setting.
¾
This unit’s IP address is used by another device. Check the
IP addresses of this unit, personal computers, and routers,
etc. If necessary, reconfigure them to avoid IP addresses
from being duplicated.
Connection test could not be conducted.
IP address is not set correctly.
¾
Turn the unit off. Disconnect the power source (the AC
adaptor or battery pack) and reconnect it and try again. If the
same symptom persists, then consult your dealer.
Connection test was unsuccessful. No reply
from Gateway. Please check the connection or
setting of the router.
¾
If you use a hub, then check the connection between the hub
and the router. (
>
31)
j
Use the UPLINK port of the hub to connect to a router.
j
If the hub’s Link lamp does not light up, then check the
cable connection, LAN terminal connection, cable itself (a
crossover cable may have been used by mistake), etc.
¾
Check the “IP Address”, “Subnet Mask”, and “Gateway
Address” in the “IP Address / DNS Settings”. (
>
42)
¾
If the MAC address information is required, then press
[SETUP] to display the “Network” menu. (
>
42)
Cannot connect.
Please confirm Network Settings or BD-Live
Internet Access in Setup.
¾
When you set “BD-Live Internet Access” to “Limit” and play
BD-Live contents which do not have a content owner
certificate, the Internet access of the content is not allowed. If
you allow the content to connect to Internet, set “BD-Live
Internet Access” to “Permit”. (
>
39)
The current security setting of Wireless LAN is
low. It is recommended to change the setting.
¾
Authentication type for the Wireless LAN is set to “Open
system”, or the encryption type is set to “No encryption”. It is
recommended to encrypt for safety reasons. For details, refer
to the instructions of the Wireless router being used.
Encryption is required when playing back video, etc., from
DLNA compatible devices.
DMPB500EB-VQT2J83_eng.book 49 ページ 2010年3月30日 火曜日 午後3時42分