9
Bef
ore Use
Replace battery with Panasonic PART NO. VSBW0004 (CR2025) only. Use of another battery may
present a risk of fire or explosion.
Caution: battery may explode if mistreated. Dispose of used battery properly. Keep away from
children. Do not recharge, disassemble or dispose of in a fire.
+
Replace the Battery
A
Before Using
You can control any two Panasonic
Palmcorders with one Remote control
(Optional). In order for the remote to
distinguish between the two units, it is
necessary to set one of the Palmcorders to
VCR 2. On the remote, press VCR 1 or
VCR 2 to control the desired Palmcorder.
Remote Controlling Two
Palmcorders
Note
1
Set POWER to VCR or CAMERA.
• The POWER Lamp lights red.
• Be sure POWER is fully turned to
VCR or CAMERA position.
2
Press MENU
to display the VCR or
CAMERA mode menu screen.
3
Rotate JOG KEY
to select
SET-UP
in
the CAMERA mode menu screen or
PLAY MODE
in the VCR mode menu
screen, then
press JOG KEY
to
display the CAMERA SET-UP or VCR
PLAY MODE menu screen.
4
Rotate JOG KEY
to select
REMOTE
,
and then press JOG KEY to select
VCR 2. (Menu OSD: pp. 105, 106).
Leave the other Palmcorder set to
VCR1.
5
Set the Remote Control (Optional) to
VCR 1 or VCR 2
to correspond with
the Palmcorder you wish to control.
(See above left.)
• When the Palmcorder and remote are
not set to the same mode (VCR1 or
VCR2), “CHECK REMOTE MODE
(REMOTE)” will appear.
• After replacing the Remote Control
Battery, the remote will default to VCR 1.
Optional
1
Insert a slender pointed object, such as the tip of a ball-
point pen into the slot so that it fits into the hole (as shown
A
). Then, while sliding to the right, pull the Battery Tray out
with your fingernail.
2
Insert the battery
into the Battery Tray with the
+
mark
facing down.
Do not reverse the polarity.
3
Insert the Battery Tray.
B
Optional
For VCR 2:
Press these
buttons at the
same time.
For VCR 1:
Press these
buttons at the
same time.
DV102.p 5-9.p65
02/03/05, 12:56
9
