- 11 -
7. Shower Hanger installation.
Screw
Upper Rail Holder
Upper Rail Holder
Install the Rail Holder so that the Shower
Head height not Higher than the unit top.
Make sure the wall level must be same to the Rail
Holder fixing position. If the wall is not at the same
level, please use spacer (not included) to fix the
accessory.
Install the Upper Rail Holder on the wall but
not higher than the unit top.
Tighten the Upper Rail Holder with 1 screw.
Prepare the Shower Hanger and Sliding Rail,
remove the Shower Hanger Knob by turning
it (anticlockwise) then install the parts
following the number (1), (2), (3) and (4).
Note: Make sure hole of Shower Hanger (1)
is align with hole of Shower Hanger (2) and
slot the Sliding Rail.
Adjust the Shower Hanger at the
required level and hang the Shower
Head as shown in diagram below.
Tighten the Shower Hanger with
Shower Hanger Knob.
Shower Hanger
Knob
Hole align
* Shower Hanger will drop off easily
once the knob is loosen.
Sliding Rail
Shower Hanger
Knob
Hole to fix Shower Head
Top
Bottom
Sliding Rail
(1)
(2)
(4)
(3)
Shower Head
Shower Hanger
Shower Hanger
Shower Hanger
Install to the Upper and Lower
Rail Holder with the Grooves
of the Sliding Rail inserted to
the Rail Holder's Notches.
Tighten the Lower Rail Holder
with 1 Screw (Make sure to
insert the Wall Plugs into the
screw hole).
Cover the Upper and Lower
Rail Holder with the Rail
Holder Covers.
Upper Rail Holder
Cover
Lower Rail Holder
Cover
Notch
Screw
Groove
Sliding Rail
Tighten the Screw if
Shower Head moves
downward.
3 TEST OPERATION
2. • Turn “On” the Main Water Valve.
• Turn clockwise the Water Volume Knob.
• Check if water leaks from the Pipe Line.
3. • Press the Push On-Off Lever once, the ELB lamp lights and water start flowing out of the Shower Head.
• Turn the Power Selector Knob clockwise and hot water flows out. (Adjust to suitable water temperature.)
4. • Refer detail for HOW TO USE and WATER FLOW RATE ADJUSTMENT on page 5.
1. • Before switch “ON” electricity check the wiring.
• Switch “ON” the Miniature Circuit Breaker (MCB) and ON/OFF DP (double pole) Switch.
• Set the ELB of the unit to “On”. (Push up the ELB Reset Lever if it is down)
• Push the ELB Test Button.
• It is normal if the ELB turns “Off” (the ELB Reset Lever falls) and push the ELB Reset Lever up.
Refer figure as shown.
• Inspection on the built-in ELB (once a month) to avoid a hazard to users such as damage to property, serious
injury or death.
3. TEST OPERATION
Push
ELB
Test Button
ELB
Reset Lever
If the ELB Reset Lever cannot be set even if you push it up or if it soon
slides down during operation, please do not use the unit and contact
the authorized dealer immediately.
Never fix the ELB Reset Lever forcibly with tape, etc.
WARNING
Shower Head
Lower Rail Holder
Power Selector
ELB Test
DH -4 MP 1
Push On-Off
ELB Reset
Push Up
