EN10
Note:
• For same level holes, use suitable tool to ensure the hole levelness.
Make two holes for Wall Hook at the wall by means
of a drill based on the marking A in
Table 1
.
Drive the Wall Plug A into each hole.
50 mm
Ø10 mm
Wall Plug A
Make one hole for Safety Hook at the wall by means
of a drill based on the marking B in
Table 1
.
Drive the Wall Plug B into the hole.
Insert the Wall Hook into Wall Plug A. Make sure the whole thread of the Wall
Hook is in the wall. Do not overtighten the Wall Hook. After fully tighten the Wall
Hook, if it is not at upward position, adjust the Wall Hook by turning it anti-clockwise
until it is at upward position as shown in
Figure 3
. This is to ensure the Wall Hook
accommodate the weight with full load and maintain the appliance stability.
Before hanging the appliance to the wall, install the Safety Hook at the back side of the appliance.
Kindly refer fi gure as below:
1. Screw the Safety Hook at the back of the
appliance
by using provided Screw A
in the Installation Packing. Refer below
position.
2. Make sure the Safety Hook is securely tight. Fasten the
Screw A to secure the Safety Hook with 1.3 N.m (13 k
g
f.cm)
torque.
Install Safety Hook at this position
DH-30HAM
View A
View A
Install Safety Hook at this position
DH-20HAM
View A
Install Safety Hook at this position
DH-15HAM
View A
Lead the Power Cord from the appliance thru the designated position. Make sure that Power Cord is not
trapped between the appliance and wall.
Cord holder structure for
Power Cord to be slotted-in
Power Cord
25 mm
Ø6 mm
Wall Plug B
Wall
Hook
Figure 3
DH-30_20_15HAM_ENVT.indb 10
DH-30_20_15HAM_ENVT.indb 10
6/17/2019 1:40:24 PM
6/17/2019 1:40:24 PM
