EN8
HOW TO INSTALL STORAGE WATER HEATER
WARNING
ƪ
Do not install, remove or reinstall the appliance by yourself.
• Improper installation will cause leakage, electric shock, fi re or injury. Installation and wiring must be done
by competent personnel.
ƪ
Never install Safety Valve at the outlet.
ƪ
Do not use unspecifi ed cord, modifi ed cord, joint cord or extension cord for power supply.
ƪ
Do not use extension cord or share the single outlet with other electrical appliances. Poor contact,
poor insulation or over current will cause electric shock or fi re.
ƪ
Do not tie up the Power Cord into bundle. Abnormal temperature rise on Power Cord may happen.
ƪ
The appliance must be earthed. Make sure the Power Cord securely connected to the Power Outlet.
Improper grounding may cause electric shock.
ƪ
This appliance should be installed and serviced by competent personnel and only genuine spare parts
should be used. If not, it may cause fi re or result in improper operation.
ƪ
During installation process make sure electrical and water supplies are turned off.
ƪ
Use the appliance under the allowable rated voltage conditions. If not, it may cause an electric shock
or fi re.
ƪ
Install at strong and fi rm location which is able to withstand more than 4 times weight with full load of
the appliance. Improper installation will cause the appliance to fall and cause injury.
ƪ
The piping installation work must be fl ushed before appliance is connected to remove contaminants.
Contaminants may damage the appliance components.
ƪ
Use the attached accessories parts and specifi ed parts for installation. Otherwise, it may cause the
appliance to fall, water leakage, fi re or electric shock.
ƪ
Ensure the Power Cord is not pinched by the product body during and after installation.
CAUTION
ƪ
This appliance must be installed indoor only.
ƪ
After installation, check the water leakage condition in the connection area during test run. If leakage
occurs, it will cause damage to other properties.
ƪ
Ensure the Storage Tank is completely fi lled with water fi rst (which can be indicated by the steady fl ow
of water at the Hot Water Faucet that set at open) before switching on the electrical supply to avoid
damage to the appliance that caused by excessive heat.
ƪ
It may need more than one person to carry out the installation work. The weight of the appliance might
cause injury if carried by one person.
ƪ
Select a location where in case of water leakage, the leakage will not cause damage to other
properties.
ƪ
Carry out the drainage piping as mentioned. The water may drip from the discharge pipe of the Safety
Valve may enter the room and damage the furniture and this pipe must be left open to the atmosphere.
BEFORE INSTALLATION
• Installation must be done by competent personnel.
• All plumbing works must be completed and the Storage Tank is fully fi lled with water before proceeding to electrical
connections. This will prevent any damage to the appliance.
• Use appropriate pipes for the inlet and outlet connections which can withstand high temperature and pressure.
For Installer
DH-30_20_15HAM_ENVT.indb 8
DH-30_20_15HAM_ENVT.indb 8
6/17/2019 1:40:18 PM
6/17/2019 1:40:18 PM
